Hikity 9601 MP5 and FM Receiver 7.0-Inch TFT LCD Instruction Manual

Hikity 9601 MP5 and FM Receiver 7.0-Inch TFT LCD

INSTALLATION

• Please read the following notice before installation *

  1. Make sure that you or the professional are using our original connector in your first installation, otherwise it could cause a short circus in the radio because the order of the cable does not match correctly. If you use another connector, the radio may not turn on or make any sound, even when you use our original connector for the second attempt. Any damage caused by misuse of the wiring will not be included in the term of the warranty.
  2. After installing the radio, you may see some regular problems that most buyers can see, but most of which can be verified and resolved by “F&Q” Remove the stereo carefully from the box. keeping the box. For warranty and service of the unit.
  3. Remove the screws.
  4. Unpack the car’s dashboard and mounting bracket.
  5. Check the size of the board window to meet the requirements. The holes of the lefit alignment screws and the right plates.
  6. By machine support fixed with screws in the dashboard.
  7. Control panel installed.

PRECAUTIONS

• Choose the mounting location carefully so that the unit will not interfere with the normal driving functions of the driver.
• Avoid installing the unit where it would be subject to high temperatures, from direct sunlight or hot air from the heater, or where it would be subject to dust, dirt or excessive vibration.
• Use only the supplied mounting hardware for a safe and secure installation.
• Adjust the mounting angle as desired.
  Note : Keep the release Key in the safe place as you may need it in future to remove the unit from the car.

WIRING DIAGRAM

WARNING: Use the specified amperage fuse for each lead. Using a higher amperage fuse may cause serious damage.

Power Cables Wiring:

• Black 1 — Ground
• Black 2 — Ground
• Red — 12V positive Ignition Switch （ACC）
• Yellow — 12V Battery positive
• Blue+Black– Steering wheel Control line
• Orange — Small Light Line
• Brown 1– Steering Wheel Control Line
• Blue — Power Antenna / Amplifier Turn on
• Pink — Backing Line
• Brown 2 — Steering Wheel Control Line

Speaker Cables Wiring: There are four groups of speaker cables, green, grey, white and purple. Each color is one group, and one group connects to one speaker’s positive wire and negative wire.

Camera Wiring:

1. Power cable: red and black
   Red — reverse light positive
   Black — reverse light negative

2. RCA cable: yellow port. insert into CAMIN port (yellow) on the radio

3. Make sure the pink cable on the radio power cable is connected to backing line. Thus, the device will show rear view image automatically when you are parking, and return to radio page when parking finishes.

SPECIFICATIONS

FM TUNER

• Frequency Range 87.5-108MHz
• Sensitivity 10 dBu
• I.F. Frequency 10.7MHz
• Frequency Response 80Hz-12kHz (±3dB)
• Stereo Separation >25dB
• S/N Ratio >50dB

GENERAL

• Power Supply Voltage 12 V DC, Negative Ground
• Max Current Consumption 15 A
• Max Output Power 4x55W
  Note : Specifications and the design are subject to possible modification without notice due to improvement.

F &Q:

1. Language Setting: Setting- Language

2. Why can’t watch video, showing ‘video warning’? Please click ‘Setting – other – video warning’ and turn ‘video warning’ off.

3. Why can’t use GPS?
   Please try to re-activate the SD map card.
   Steps:

4. Remove the SD card, make sure there is no dust on it, and put it back in the unit

5. Click “Navigation/GPS – Setup – Navi Path” – “Primo” – “Primo.exe” – “Load Map Automatically” – “”.

6. Return to the home page and click “Navigation” to load the map, start to use it

7. If the map is still empty, click on the map to show “+”and “-” button, click “+” to magnify the map until it shows streets

8. Why the car radio shows “No Signal” when I’m reversing?
   If the camera can light up when it connect to power, the camera can work. Then please  check if the camera’s lines are wired correctly, exactly as written in “camera wiring”.

Service

Any question or problem, please contact us via order page. We will respond within 24 hours. P. S. If possible, photos or video can help us to confirm the problem faster.

Main Functions

INSTALLATION

PRECAUTIONS

• Choose the mounting location carefully so that the unit will not interfere with the normal driving functions of the driver.
• Avoid installing the unit where it would be subject to high temperatures, from direct sunlight or hot air from the heater, or where it would be subject to dust, dirt or excessive vibration.
• Use only the supplied mounting hardware for a safe and secure installation.
• Adjust the mounting angle as desired.

MOUNTING EXAMPLE

Installation In the dashboard
Note: Keep the release Key in the safe place as you may need it infure to remove the unit from the car.

WARNING
Use the specified amperage fuse for each lead. Using a higher amperage fuse may cause serious damage.

FEATURES

The Unit Features MPS/USB/SD Ports and 7.0 inch TFf LCD

• Electronic Pll Tuning Control with 18 Programmable Stations
• MP3/WMA Compatible
• Preamplified Line-out
• Front Audio Aux-in
• USB Port and SD/MMC Input
• Last Track Memory (RADIO & SD/MMC & USB)
• 7.0 inch TFT LCD

REMOTE CONTROL GUIDE

1. Power/Mule
2. SRC & End Call
3. Play/Pause
4. Band(swilch ror FMI-FM2-FM3) & Answer Call 1:1
5. Press
6. Next
7. AMS
8. Vol-
9. Vol+
10. Audio& NO.0
11. A.V.P.
12. System Menu
13. IE 0.1
14. NO.2
15. NO. 3
16. NO. 4
17. NO.5
18. NO.6
19. NO.7 & RPT
20. NO.8 & INT
21. NO.9 & SUB-T

LOCATION OF CONTROL

1. PWR: Power ON/OFF
2. MODE: Function Selector (radio/usb/sd/aux-in/bt) & End Call
3. AMS: Auto Seek Search Tuning
4. BAND: Band Bullon (FM 1-FM2-FM3) & Answer Call
5. /6.1+1/-.+1: Short press: Prev/Next, Long press:Fast forward / rewind; Manual Auto Search Radio
6. /6.1+1/-.+1: Short press: Prev/Next, Long press:Fast forward / rewind; Manual Auto Search Radio
7. SD : Micro SD Card Slot, GPS navigation map card slot (optional model)
8. AUX IN: AUX IN Jack
9. USB: USB Port
10. LCD: LCD Display
11. VOL/SEL: Volume / Select Control
12. MUTE: Mute ON/OFF
13. DISP: Clock Display
14. EQ: flat-pop-classic-rock/ NA VI: Enter the navigation interface (optional model)
15. Return to the previous level

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>