LENOXX 90313 Childrens Electronic Battery-Operated Motor Tricycle Instruction Manual
- June 6, 2024
- lenoxx
Table of Contents
CHILDREN’S ELECTRONIC BATTERY-OPERATED MOTOR TRICYCLE
OPERATIONAL INSTRUCTIONS
Model no: 90313
Batch no: PR4411
Read this manual in detail before use and retain this instruction manual for future reference.
The illustrations used in the manual are to illustrate the operation method and structure of the product. Where there is a small difference between the physical item and the illustrations, please take the physical as the standard.
SPECIFICATIONS OF THE MOTOR TRICYCLE:
Age range: 3 – 7, dependent on weight and height of the child
Max speed: 3km/h
Measurements: 80cm x 36cm x 52cm
Battery: Sealed and dry, 6V 4.5AH
Charging time: 8 – 12 hours
Run time after a full charge: up to 1 hour
Loading capacity : 20kg
Fuse: 5 amp
WARNING:
Keep small parts and packaging out of reach of children. Adult supervision is
required. Do not drive anywhere dangerous including slopes with more than 10
degrees, streets, next to bodies of water, and away from other obstacles. The
driver must sit on the seat to drive. Read the instruction manual and
acknowledge it before use.
- Adult supervision required
- Read the instruction manual and instruct the child user
- The weight limit is 20kg
- Only one rider to use at the one time
- Please wear a bike helmet when riding
- Sit straight on the seat when riding
- Ride only on flat surfaces
- Ride away from other vehicles and bodies of water
- Recharge the batteries out of reach of children
- Do not charge the battery for more than 12 hours
- Wear shoes when riding
- Only use a power adaptor and battery by the manufacturer’s advice
SAFETY:
PREVENT INJURIES AND DEATHS: NEVER LEAVE CHILD UNATTENDED. DIRECT ADULT
SUPERVISION IS REQUIRED.
Please instruct the child on the correct way to drive the motor tricycle. Make
sure your child knows how to steer, how to start and stop the vehicle, and
knows the rules for safe driving. Please keep in mind the condition of the
area they are riding in and the child’s driving ability. Designed for use by
children between the ages of 3 – 7 years, weighing
less the 20kg. This is advisable to avoid damage to the motor, gears and to
prohibit overloading. Do not let children ride in the street, anywhere
dangerous including slopes with more than 10 degrees, streets, next to bodies
of water, and away from other obstacles. Use during daylight hours or in an
illuminated area is advised to avoid accidents in the dark. When the motor
tricycle is running, do not place anything on the moving parts such as the
motor, gearbox, wheels, or steering wheel. Do not drive on long or wet grass,
mud, soft ground, gravel, or sand. Do not drive neat anything flammable or
explosive. Keep any hazardous chemicals out of the driver’s reach. The vehicle
can be driven at a maximum of 3km/h. Always keep the child in view when a
child is using the ride-on. This toy should be used with caution since skill
is required to avoid falls or collisions causing injury to the user or third
parties. Protective equipment should be worn. Never use in roadways, near
cars, on or near steep inclines or steps, swimming pools, or other bodies of
water.
Always wear shoes.
Always sit on the seat.
Not to be used in traffic.
This ride-on has no brake.
CONNECTING THE BATTERY:
The battery is located under the sea
To access, remove the screw using a screwdriver (not included) holding the
heat down and then take the seat off the body.
If the battery is not connected and you charge the motor tricycle, the battery
will not be charging.
Plug the red connector onto the red terminal of the battery. Plug the black connector onto the black terminal of the battery.
If the battery is not connected and you charge the motor tricycle, the battery
will not be charging. The forward/reverse switch must not be on either mode
when charging.
Charging time is 8 – 12 hours. The first hour of charging can get back 60% of
the battery’s energy back. You may leave it to charge overnight, but NEVER
continuously over 20 Hours. Otherwise, you will shorten the battery’s life. It
is normal for the battery to be warm when charging. The motor tricycle must be
charged prior to its first use. Working AC voltage is 220V (or 110V) (+/-10%).
CHARGING THE BATTERY:
Insert the plug of the charger into the charging socket which is on the main body of the bike below the siren and music buttons. Connect the charger to the motor tricycle first, and then connect the plug to power. Please note, the motor tricycle cannot be driven when charging. Do not insert any metal pieces into the charging hole to avoid short-circuiting and any damage to the electro circuit. This vehicle has a function of charging protection and while it is being charged, other functions cannot be used. The charger needs to be removed from the charging socket before it is used. Once the charger is removed, put the motor tricycle into either forwards or reverse mode, then press on the foot pedal. This vehicle also has the function of overload protection. If the vehicle is overloaded or operated incorrectly, the overload preventer will cut off automatically. It will connect automatically in 20 minutes.
OPERATION:
- Step on the pedal to start, lift your foot off the pedal to stop.
- Press go-ahead to go forward, press back to reverse. When the forward/backward switch is not on either mode, the bike will not drive.
- When in go forward, the headlight will be on.
- When in backward, the taillight will be on.
- Press the alarm button to hear the siren, press the music button to hear the music.
ASSEMBLY:
Warning: Children could be injured by sharp edges, sharp angles, small
components or electrical components. Take care when assembling or
disassembling the motor tricycle. Keep the components and battery out of reach
of children.
Screw and washer pack:
Total fittings:
2 x nuts to attach the front wheel
4 x washers to attach the front wheel
3 x screws needed to attach the light cluster to the front handlebars
3 x screws needed to attach the plastic windshield to the front handlebars
2 x screws needed to attach the siren light to the toolbox
2 x screws needed to attach the toolbox to the bike
1 x washer spare
2 x screws spare
2 x plastic socket/spanner for tightening the nuts Screwdriver (not included)
required for assembly.
Assembling the front wheel:
- The method from one side to the other when completed will be: Nut, washer, pass through the hole of the fork, washer, wheel cap, wheel, wheel cap, washer, pass through the hole of the fork, washer, nut.
- Put on the wheel caps onto the front wheel on both sides.
- Insert the front axel onto the holes of the fork.
- Put a washer on each side of the wheel.
- Fasten the nut on each side with a spanner.
Add the front-wheel cover by clipping it onto the fork above the front wheel.
Fix the windshield onto the headcover with three self-tapping screws. Fix the headcover onto the bracket on the handlebar using 3 self-tapping screws. Ensure the headlight lead is passed through the back of the handlebars for connection later on.
Attach the plastic gauge piece to the front bars as below.
Add the toolbox to the main body of the bike. Insert the wires of the siren light through the holes of the toolbox. Fix the alarm light using 2 self- tapping screws. Connect the two parts of the two toolboxes (as shown in the above diagram).
Connect the wires of the siren light to those of the main body of the bike. Fix the toolbox to the body of the bike using 2 “3×12” washers and 2 self- tapping screws.
Join the main body of the motor tricycle to the front end with the front wheel using the bolt and washer and nut included. Use the included plastic spanner to screw the bolt clockwise.
Use the nut to screw onto the bolt to hold the pieces tightly together. Use the included plastic spanner to screw the bolt clockwise. Headlight connection: Once the main body and the front end of the motor tricycle are joined, you can then connect the wires from the main body to the wires on the front end. This is optional if you would like the motor tricycle to have a headlight come on when the pedal is pressed down and the motor tricycle is driving.
MAINTENANCE AND TROUBLESHOOTING:
Factors that may influence the motor tricycles performance and life span:
– How flat the driving surface is
– The weight of the driver
– Whether the battery has been fully charged
– Whether the motor tricycle is regularly used
– Whether water or any other liquid has eroded the electrical components
Cleaning:
Clean the motor tricycle with a soft dry cloth. Do not use any wax or spray
liquids for cleaning. It could erode the power switch.
Storage:
Do not store the motor tricycle in an area of high temperature, humidity, or
near flames. When raining or snowing, keep the motor tricycle undercover and
out of the weather. Do not change the batteries setting, as it can cause fire
and damage the electrical circuit system. Do not change the motor tricycles’
electrical circuit system. Any repairs done to this unit must be carried out
by authorised and qualified service personnel. Do not allow children to charge
the motor tricycle, play with the battery or motor. If the motor recycles will
not be used for a long period of time (3 months or longer), it is advised that
you fully charge the battery and disconnect it from the connections. A long
period of non-use will damage the battery. It is advised that the battery
should be charged once a month, even if the motor tricycle is not being used.
A new battery must be fully charged before its first use. Please take care
with the battery as it contains acid electrolytes. Handling of the battery by
adults only. If the battery has leaked, do not touch the acid. Place the
battery into a polybag and dispose of it. If the electrolyte splashes on your
skin or into your eyes, immediately wash with water for at least 15 minutes
and consult your doctor. Do not contact the battery’s two terminals with any
other metal objects. It will cause short-circuiting, damage, or fire. Adjust
the f/r switch to on and press the siren button to check for power. If you
hear no music, check that the battery has been joined up correctly. Correct if
required. Never push or pull the motor tricycle backward when it is running.
Do not plug the charger into any non-working or faulty wall socket. This could
cause short-circuiting or fire. In the circumstance of unstable voltage, we
suggest that you equip a regulator.
www.lenoxx.com.au
1300 666 848
LenoxxElectronics
LenoxxElectronics
@LenoxxAustralia