SONIC MODELL SonicModell AR WING PRO User Manual

: June 6, 2024
: sonic modell

Table of Contents

SPECIFICATIONS:
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Thank you for purchasing a SonicModell product!

THE NEW BENCHMARK FOR FPV WINGS
Ideal for beginners and experienced pilots alike. Tough, fast, and extremely maneuverable. Smart design for better FPV gear placement.

SPECIFICATIONS:

Material: High Quality EPP
Wingspan: 1000mm (39.37″)
Length: 450mm (17.71″)
Motor: 2216-1400KV
ESC: 40A w/5V 3A BEC
Servos: 2pcs Analog Metal Gear 9g
Propeller: 2 blades 8×5
Recommended Battery: Lipo 4S 3200-3500mAh ZOHD Lionpack 18650 4S2P 7000mAh

This unit is designed to carry the DJI HD FPV System without any mods.

Min recommended speed: 31km/h
Max speed (with SONICMODELL power combo): 130km/h
Cruise speed (with SONICMODELL power combo): 75/80km/h @ 5.5A
Max speed tested without structural failure: 220km/h with no structural damage or twist on elevons
Max recommended take-off weight (with SONICMODELL power combo): 1425 grams
Reflex on elevons: 1.5-2mm at level Recommended max. throws: 12mm

Thanks to Painless360 for the support during development.
Follow us on In

Contact us: info@sonicmodell.com sales@sonicmodell.com
Customer service: cs@sonicmodell.com
www.sonicmodell.com

Use the 2 provided screws to fix the wingtips. Is not a bad idea to also glue them for extra strength on landings.

This unit is specially designed to host the DJI HD FPV system. You have a top hatch and a nose dedicated to it. You can also place the DJI system on the side bays, but we recommend you use the central placement for better cooling and horizontal balance.

Use the thumbscrews to secure the wings for flight. After wing, removal screws them back into place to avoid losing them.

The especially air-cooled side bays open to the sides for you to place any gear you want.

Please stick the Teflon landing skin according to the graphic.

If you plan to install the provided CA hinges, please cut the EPP following the markings on the wings and elevons for proper alignment. Also, make sure you leave around lmm clearance between the elevon and the trailing edge of the wing so the control surface can move freely. Don’t overdo with the glue!

CAUTION:

You will need EPO/EPP safe glue to assemble this unit. Please be sure you have the right type of glue testing on a scrap piece of foam from the kit.
This product is NOT a toy. Adult supervision is required for those under 14 years old. improper adjustments and operation will result in damage to the item and/or injuries to the operator. Experience is required prior to handling this product.