CONAIR CD160PPCS Dual Voltage Curling and Styling Brush Instruction Manual

CONAIR CD160PPCS Dual Voltage Curling and Styling Brush

IMPORTANT SAFETY INSTRUCTIONS

When using electrical appliances, especially when children are present, basic safety precautions should always be followed, including the following:

READ ALL INSTRUCTIONS BEFORE USING
KEEP AWAY FROM WATER
DANGER – Any appliance is electrically live even when the switch is off.
To reduce the risk of death or injury by electric shock:

1. Always unplug appliance immediately after using.
2. Do not use while bathing or in a shower.
3. Do not place or store appliance where it can fall or be pulled into a tub or sink.
4. Do not place in, or drop into, water or other liquids.
5. If an appliance falls into water, unplug it immediately. Do not reach into the water.

WARNING – To reduce the risk of burns, electrocution, fi re, or injury to persons:

1. This appliance should never be left unattended when plugged in. Do not pull, twist, or wrap line cord around appliance.
2. This appliance should not be used by, on, or near children or individuals with certain disabilities.
3. Use this appliance only for its intended use as described in this manual. Do not use attachments not recommended by the manufacturer.
4. Never operate this appliance if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged or dropped into water. Return the appliance to an authorized service center for examina-tion and repair.
5. Keep the cord away from heated surfaces.
6. Never block the air openings of the appliance or place it on a soft surface, such as a bed or couch, where the air openings may be blocked. Keep the air openings free of lint, hair, and the like.
7. Never use while sleeping.
8. Never drop or insert any object into any opening or hose.
9. Do not use outdoors or operate where aerosol (spray) products are being used or where oxygen is being administered.
10. Do not use an extension cord with this appliance.
11. Do not direct hot air toward eyes or other heat-sensitive areas.
12. Attachments may be hot during use. Allow them to cool before handling.
13. Do not place appliance on any surface while it is operating.
14. While using the appliance, keep your hair away from the air inlets.
15. Do not operate with a voltage converter.
16. Be sure dual voltage selector is in the correct voltage position before operating. Before plugging in, read the information about dual voltage contained in this booklet.
17. This appliance was set at the factory to operate at 125 volts. Refer to information in this booklet for conversion to 240/250 volt operation.

OPERATING INSTRUCTIONS

This appliance is intended for household use. Use on Alternating Current (60 hertz) only. This appliance is designed to operate at 110 to 125 volts AC or 220 to 250 volts AC.

FOR DUAL VOLTAGE HOT BRUSH
For use in the U.S.A., the voltage selector switch should be placed in 125 positions. For use in several countries overseas, the voltage selector may need to be placed in the 250 positions. Confi rm the voltage available at each overseas location before using the appliance. For connection to a 240 volt supply, use an attachment plug adapter of the proper
configuration for the power receptacle.

For 110–125 Volt Operation
Flick the dual voltage switch to the 125 positions. In this position, the appliance operates in all available heat and speed settings.

For 220–250 Volt Operation
First put the HI–LO switch on OFF. Flick the dual voltage switch to the 250 position. At 220–250V while set at LO, the appliance operates only at LO heat and speed settings. Do not attempt to operate the HI-LO switch or change to 125 when operating on 220–250. The switches must be set and remain in the LO and 250 positions. A plug adapter may be necessary in certain countries.

ADDITIONAL INFORMATION
This appliance has a polarized plug (one blade is wider than the other). As a safety feature, this plug will fi t into a polarized outlet only one way. If the plug does not fi t fully into the outlet, reverse the plug. If it still does not fi t, contact a qualifi ed electrician. Do not attempt to defeat this safety feature.

CHECK ALCI SAFETY FEATURE EVERY TIME YOU USE APPLIANCE.
This appliance is equipped with an Appliance Leakage Circuit Interrupter (ALCI), a safety feature that renders it inoperable under some abnormal conditions, such as immersion in water. To make sure the ALCI is functioning properly, perform the following test. The purpose of this test is to allow you to make sure the water sensing system (ALCI) is working.

1. Plug in the appliance and press test button on plug (see appropriate diagram at right).
2. The appliance will stop working. There will be an audible click and reset button will pop out.
3. To reset ALCI with a reset button, unit should be unplugged. Then push in reset button and reinsert plug into outlet.
4. If ALCI is not functioning properly, return appliance to nearest service center.
5. It is important that if immersion occurs, this unit be brought to a service center. Do not try to reset.
6. Be sure to repeat test every time you use the unit, to confi rm ALCI is operational. Should the appliance go off and the reset button pop up during use, this could indicate a malfunction in the unit. Remove plug from outlet and allow the hot air brush to cool. Reinsert plug into outlet.

HOW TO STYLE WITH YOUR HOT AIRBRUSH

To create, lift, or set medium, soft curls use the 1-inch brush on partially dry hair. Beginning at the crown area, take a small section of hair and place the 1-inch brush near the root area. Slide the hot air brush toward the ends, then wind hair back toward the root area. Hold for approximately 10 seconds, then gently unwind hair from the brush without using tension. Continue throughout your hair until you get the style you want.

To create volume, wave or body, use the 1½-inch brush on partially dry hair. The Hot Air Brush can create lift and large, soft curls.
Beginning at the crown area, take a section of hair and place the 1½-inch hot air brush near the root area. Slide the hot air brush toward the ends, then wind toward the root area. Hold for approximately 10 seconds, then gently unwind the hair without tension. Continue throughout the hair until all the hair has been curled.

USER MAINTENANCE

Your appliance is virtually maintenance free. For proper performance, the appliance must be kept clean. Blocked or clogged air intake vents will cause the appliance to overheat. When cleaning is needed, unplug the cord and clean dust and lint from air intake openings with a small brush. The outer surface of the appliance should be wiped clean with a cloth only. If abnormal conditions occur, unplug the appliance, allow it to cool and return it for repair to an authorized service representative only. No repairs should be attempted by the consumer.

DUAL VOLTAGE

Be sure the dual voltage selector is in the correct voltage position before operating. This appliance was set at the factory to operate at 125 volts. Before plugging in, read the information about dual voltage contained in the Operating Instructions section of this booklet.

GET TO KNOW YOUR STYLER

*IF YOU MUST USE YOUR HAIR DRYER IN THE BATHROOM, INSTALL A GFCI NOW!
Your local electrician can help you decide which type is best for you – a portable unit that plugs into the electrical outlet or a permanent unit installed by your electrician. The National Electrical Code now requires GFCIs in the bathrooms, garages, and outdoor outlets of all new homes.
WHY DO YOU NEED A GFCI?** Electricity and water don’t mix. If your hair dryer falls in water while it’s plugged in, the electric shock can kill you…even if the switch is off. A regular fuse or circuit breaker won’t protect you under these circumstances. A GFCI offers you far greater protection.

A GFCI can save your life! Compared to that, the price is small! Don’t wait…install one now!
*A GFCI is a sensitive device that reacts immediately to a small electric current leak by stopping the electricity flow.

CAUTION – NEVER allow the power supply cord to be pulled or twisted. Never wrap the cord around the appliance. Damage will occur at the high fl ex point of entry into the appliance, causing it to rupture and short circuit.
Inspect the cord frequently for damage. STOP USE IMMEDIATELY if damage is visible or if unit stops or operates intermittently.

STORAGE
When not in use, your appliance should be disconnected, allowed to cool and stored in a safe, dry location out of reach of children. Do not wrap the line cord around the appliance. Allow the cord to hang or lie loose and straight at the point of entry into the appliance.

WARNING:
IF YOU THINK THE POWER IS OFF WHEN THE SWITCH IS OFF, YOU’RE WRONG.
KEEP AWAY FROM WATER

Everyone knows that electricity and water are a dangerous combination. But did you know that an electric appliance is still electrically live even if the switch is off?
If the plug is in, the power is on. So when you are not using your appliances, keep them unplugged.
ALWAYS UNPLUG SMALL APPLIANCES

LIMITED ONE YEAR WARRANTY

Conair will repair or replace (at our option) your unit free of charge for 12 months from the date of purchase if the appliance is defective in workmanship or materials.
To obtain service under this warranty, return the defective product to the service center listed on back, together with your purchase receipt and
$7.50 for postage and handling. California residents need only provide proof of purchase and should call 1-800-3-CONAIR for shipping instructions. In the absence of a purchase receipt, the warranty period shall be 12 months from the date of manufacture.

ANY IMPLIED WARRANTIES, INCLUDING BUT NOT LIMITED TO THE IMPLIED WARRANTY OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, SHALL BE LIMITED IN DURATION TO THE 12-MONTH DURATION OF THIS WRITTEN, LIMITED WARRANTY.

Some states do not allow limitations on how long an implied warranty lasts, so the above limitations may not apply to you.
IN NO EVENT SHALL CONAIR BE LIABLE FOR ANY SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES FOR THE BREACH OF THIS OR ANY OTHER WARRANTY, EXPRESS OR IMPLIED, WHATSOEVER.
This warranty gives you specifi c legal rights, and you may also have other rights, which vary from state to state.

Please register this product at: www.conair.com/registration
For info on any Conair product, call: 1-800-3-CONAIR or visit us on the web at: www.conair.com

SERVICE CENTER
Conair Corporation
Service Department
7475 N. Glen Harbor Blvd Glendale, AZ 85307
©2013 Conair Corporation
13PA138643

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>