CONAIR HS67 Series Gentle Curls Steam Rollers Instruction Manual

June 6, 2024
ConAir

CONAIR logo GENTLE CURLS
STEAM ROLLERS
CONAIR HS67 Series Gentle Curls Steam Rollers
INSTRUCTION & STYLING GUIDE
HS67 SERIES MODEL

12 ROLLERS INCLUDED

IMPORTANT SAFETY INSTRUCTIONS

When using electrical appliances, especially when children are present, basic safety precautions should always be taken, including the following:
READ ALL INSTRUCTIONS BEFORE USING KEEP AWAY FROM WATER

DANGER – To reduce the risk of electrocution:

  1. Always unplug this appliance immediately after using it.
  2. Do not use it while bathing or in the shower.
  3. Do not place or store appliances where they can fall or be pulled into a tub or sink.
  4. Do not place in, or drop into water or other liquids.
  5. Do not reach for an appliance that has fallen into the water. Unplug immediately

WARNING – To reduce the risk of burns, electrocution, fire, or injury to persons:

  1. An appliance should never be left unattended when plugged in.
  2. This appliance should not be used by, on, or near children or individuals with certain disabilities.
  3. Use this appliance only for its intended use as described in this manual. Do not use attachments not recommended by the manufacturer.
  4. Never operate this appliance if it has a damaged cord or plug if it is not working properly, if it has been dropped or damaged, or dropped into water. Return the appliance to an authorized service center for examination and repair.
  5. Keep the cord away from heated surfaces.
  6. Never block the air openings of the appliance or place it on a soft surface, such as a bed or couch, where the air openings may be blocked. Keep the air openings free of lint, hair, and other debris.
  7. Never use while sleeping.
  8. Never drop or insert any object into any opening or hose.
  9. Do not use outdoors or operate where aerosol (spray) products are being used or where oxygen is being administered.
  10. Do not touch the posts that hold the rollers. They are hot.
  11. Do not use a voltage converter.
  12. Do not use an extension cord.
  13. This appliance is not a toy. Keep away from children.
  14. Before plugging in the unit, read the information on DUAL VOLTAGE found under OPERATING INSTRUCTIONS.
  15. Use a hair curler heater on a level surface.
  16. When opening the lid, use the handles to reduce the risk of scalding. Stay away from the mist or steam vents.
  17. We recommend using distilled water. Fill the reservoir with water only.

SAVE THESE INSTRUCTIONS

OPERATING INSTRUCTIONS

This appliance is intended for household use. Use on Alternating Current (50/60 hertz) only. This unit is designed to be operated at 120/240 volts AC. This appliance has a  polarized plug (one blade is wider than the other). As a safety feature, this plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to defeat this safety feature.

Dual Voltage
This unit will automatically adjust to the proper voltage. Use an adapter plug with the correct configuration, prior to use in the outlet.

Prepare for use

| 1. Make sure the unit is unplugged and remove the steamer top from the reservoir before filling.
---|---
| 2. Fill reservoir to water level line with distilled water only. Do not overfill. Replace the top with rollers and plugins.
| 3. After about 90 seconds, when the unit begins to steam, the rollers are ready to use. DO NOT HEAT THE ROLLERS ON THE UNIT FOR OVER 3 MINUTES, AS THEY WILL BE TOO HOT TO TOUCH.
| 4. Roll hair around steam-infused roller.

Create curls

| 1. Place section of hair evenly on the roller and roll upward toward the scalp. Snap roller shield into place.
---|---
| 2. To create a tighter, bouncy curl, roll or wrap, but apply extra pressure while rotating up.
| 3. To wrap hair around the roller, place the roller midsection on the hair strand and roll either under or over to the scalp. Snap roller shield into place.

Unroll and style

| 1. To remove rollers, gently take off the shield. Rotate the roller downward in a dropping motion without pulling or tugging.
---|---
| 2. If desired, separate curls with fingers to loosen. Do not comb or brush. For extra volume, flip hair over and loosen at the roots.

Cleaning and storage

Empty water reservoir when not in use. Unplug the unit and allow it to cool. Remove steamer unit. Turn the unit upside down and drain. Dry the exterior with a cloth. Wrap the power cord around the unit and store it in a dry place.
Clean the unit occasionally to remove mineral buildup. Using distilled or purified water helps lessen this buildup, but in general, you should clean your hair setter after every 20 uses, more often if the water in your area is hard.

CAUTION: Never allow the power supply cord to be pulled, twisted or severely bent. Never wrap the cord tightly around the unit. Damage will occur at the high flex point of entry into the unit, causing it to rupture and short circuit. Inspect the cord frequently for damage. Stop use immediately if the damage is visible or the unit stops or operates intermittently. If the cord or unit is damaged or does not operate properly, return it for repair to an authorized Conair Service Representative only. No repairs should be attempted by the consumer. If you turn the steam unit upside down, do not put your hand over or close to the steam vent, as it may contain a small amount of hot water.

Rollers and Foams:
Pull rollers apart to clean, gently pushing back the foam to pull off the endcap. Slide foam off the core and clean in warm water with mild detergent. Rinse thoroughly, blot excess water and allow to dry completely before putting back on rollers to reuse.
IMPORTANT: After using the hair setter several times, you will find the best timing for the length and texture of your hair and for the result you desire.

CONAIR HS67 Series Gentle Curls Steam Rollers - figure
11

Styling Tips

For maximum results, use one or two rollers on the top front layer of your hair. Use the remaining rollers on the sides and back of the head. The hair should be taken in equal sections and rolled under, toward your neck. After approximately 10 minutes or when rollers have cooled, the rollers can be removed. Let hair cool for one minute and then style.

GENTLE CURLS STEAM ROLLERS

12, ¾-INCH ROLLERS AND ROLLER SHIELDS

| 12, ¾-inch diameter bare roller
---|---
| 12, ¾-inch diameter roller shields

REPLACEMENT PARTS

Model Description Price
RP67 3, ¾-inch Rollers and shields $3.99

Please add postage and handling to all orders. Postage and handling are as follows: Any order up to $10.00 – add $1.00 to order. Any order from $10.01 and over – add $1.50 to order.

Name: __
Address:

City: State: __ ZIP: __
Daytime Phone: () ____

Note: Prices are subject to change without notice. When ordering outside the continental U.S.A., consumers must include the cost for airmail and parcel post. Allow 4 to 6 weeks for delivery. Outside the U.S.A., payments must be drawn on U.S. banks, in U.S. dollars only.

Please mail to:
Conair Corporation 7475 N. Glen Harbor Blvd. Glendale, AZ 85307

GETTING TO KNOW YOUR HAIRSETTER

  • 12 ¾-inch rollers with shields
  • Perfect for all hair types
  • Steams and conditions as it curls
  • Creates long-lasting curls and volume

CONAIR HS67 Series Gentle Curls Steam Rollers

MAINTENANCE

Your hairsetter is designed for household use and is virtually maintenance- free. This product represents the highest standards of workmanship and engineering research.
If cleaning becomes necessary, disconnect the appliance from the power source. Allow the hairsetter to cool. Clean the unit with a damp cloth. (Occasionally you may want to clean the rollers. Use a damp cloth and mild detergent or soap.) If any abnormal condition occurs, unplug the hairsetter, allow it to cool, and return it to an authorized service representative for repair.

STORAGE

Allow hairsetter to cool. Handle cord carefully for longer life; avoid jerking or straining at plug connections. Place hairsetter out of reach of children in a safe, dry location.
Do not wrap the line cord around the unit. Allow the cord to hang or lie loose and straight at the point of entry into the unit.

WARNING: IF YOU THINK THE POWER IS OFF WHEN THE SWITCH IS OFF, YOU’RE WRONG.

KEEP AWAY FROM WATER

CONAIR HS67 Series Gentle Curls Steam Rollers - figure
1

Everyone knows that electricity and water are a dangerous combination. But did you know that an electric appliance is still electrically live even if the switch is off?
If the plug is in, the power is on. So when you are not using your appliances, keep them unplugged.

ALWAYS UNPLUG SMALL APPLIANCES

LIMITED THREE-YEAR WARRANTY (U.S. AND CANADA ONLY)

Conair will repair or replace (at our option) your unit free of charge for 36 months from the date of purchase if the appliance is defective in workmanship or materials.
To obtain service under this warranty, return the defective product to the service center listed on the back, together with your purchase receipt and $5.00 for postage and handling.
California residents need only provide proof of purchase and should call 1-800-3-CONAIR for shipping instructions. In the absence of a purchase receipt, the warranty period shall be 36 months from the date of manufacture.
ANY IMPLIED WARRANTIES, OBLIGATIONS, OR LIABILITIES, INCLUDING BUT NOT LIMITED TO THE IMPLIED WARRANTY OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE SHALL BE LIMITED IN DURATION TO THE 36-MONTH DURATION OF THIS WRITTEN, LIMITED WARRANTY. Some states do not allow limitations on how long an implied warranty lasts, so the above limitations may not apply to you. IN NO EVENT SHALL CONAIR BE LIABLE FOR ANY SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES FOR BREACH OF THIS OR ANY OTHER WARRANTY, EXPRESS OR IMPLIED, WHATSOEVER. Some states do not allow the exclusion or limitation of special, incidental, or consequential damages, so the above limitation may not apply to you. This warranty gives you specific legal rights, and you may also have other rights, which vary from state to state.

CONAIR logoPlease register this product at
www.conair.com/registration
Service Center
Conair Corporation Service Department
7475 N. Glen Harbor Blvd.
Glendale, AZ 85307
©2017 Conair Corporation 150 Milford Road, East Windsor, NJ 08520
7475 N. Glen Harbor Blvd., Glendale, AZ 85307

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals