CONAIR TS7X Jumbo Roller Travel Hairsetter Instruction Manual

: June 6, 2024
: ConAir

Table of Contents

Styling Tips
Documents / Resources
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)

CONAIR TS7X Jumbo Roller Travel Hairsetter Instruction Manual

CONAIR TS7X Jumbo Roller Travel Hairsetter Instruction
Manual

IMPORTANT SAFETY INSTRUCTIONS

When using electrical appliances, especially when children are present, basic safety precautions should always be followed, including the following:

READ ALL INSTRUCTIONS BEFORE USING KEEP AWAY FROM WATER

DANGER – To reduce the risk of electrocution:

Always unplug this appliance immediately after using.
Do not use while bathing, or in the shower.
Do not place or store appliance where it can fall or be pulled into a tub or sink.
Do not place in or drop into water or other liquids.
Do not reach for an appliance that has fallen into water. Unplug immediately

WARNING – To reduce the risk of burns, electrocution, fire, or injury to persons:

An appliance should never be left unattended when plugged in.
This appliance should not be used used by, on, or near children or individuals with certain disabilities.
Use this appliance only for its intended use as described in this manual. Do not use attachments not recommended by Conair.
Never operate this appliance if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged, or dropped into water. Return the appliance to a service center for examination and repair.
Keep the cord away from heated surfaces.
Never block the air openings of the appliance or place it on a soft surface, such as a bed or couch, where the air openings may be blocked. Keep the air openings free of lint, hair, and other debris.
Never use while sleeping.
Never drop or insert any object into any opening or housing.
Do not use outdoors or operate where aerosol (spray) products are being used or where oxygen is being administered.
Do not touch the bars that hold the rollers. They are hot.
Use hairsetter on level surface.
The cord can be wrapped around the stand for storage. Do not wrap the cord around any other parts of the appliance.
Do not use with voltage converter.
Do not use with an extention cord.
Be sure dual voltage selector is in correct voltage position before operating. Before plugging in, read the information about dual voltage contained in the instruction section of this manual.
This appliance was set at the factory to operate at 120 volts. Refer to Operating Instructions section of this manual for conversion to 240 volts operation.

SAVE THESE INSTRUCTIONS

OPERATING INSTRUCTIONS

How to Operate your Hairsetter

Place hairsetter on a firm, flat surface. With the lid closed, plug cord into outlet. This appliance has a polarized plug (one blade is wider than the other). As a safety feature, this plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to defeat this safety feature. For use in the
U.S.A., the voltage selector switch should be placed in the 120V position. For use in several countries overseas, the voltage selector may need to be placed in the 240V position. Confirm the voltage available at each overseas location before using the appliance. For connection to a 220–240 volt supply, use an attachment plug adapter of the proper configuration for the power supply receptacle. Adjust your setter to a higher voltage by changing the switch position, located under unit’s base.
Once plugged in, the rollers will heat up in minutes. The fastest, most efficient heat-up is provided when the lid is closed. When the red ready dot turns white, the rollers have reached optimum temperature and you can begin styling your hair (please refer to HOW TO CURL YOUR HAIR for further instruction).
Never leave your hair setter plugged in and unattended. Always unplug the hair setter when not in use. Allow the hair setter to cool down after use. Store unit in safe place.
When using the hair setter, your hair should be clean and dry (or slightly damp), never wet.

INSTANT HEAT

5 ROLLER TRAVEL HAIRSETTER

CONAIR TS7X Jumbo Roller Travel Hairsetter - INSTANT
HEAT

Features:

5 jumbo 1½ in. rollers
5 Super Clips™
Dual voltage (120 or 240 volts, 50–60 cycles AC)

*Super Clips™ and Wire Clips Offer**

CONAIR TS7X Jumbo Roller Travel Hairsetter - Super Clips and Wire Clips
Offer

To receive a box of 10 Super clips™ or 5 wire clips for your Conair hair setter, fill out order form and send check or money order to:

Conair Corporation
150 Milford Rd
East Windsor, NJ 08520

*Wire clips are not included with your hair setter

CONAIR TS7X Jumbo Roller Travel Hairsetter - Wire clips are not included
with your hairsette

Please add postage and handling to all orders. Postage and handling are as follows: Any order up to $5.00 – add $.50 to order. Any order from $5.01 to $10.00 – add $1.00 to order. Any order from $10.01 and over – add $1.50 to order.

CONAIR TS7X Jumbo Roller Travel Hairsetter - Please add postage and handling
to all orders

Note: Prices subject to change without notice. When ordering outside continental U.S.A., consumer must include cost for airmail and parcel post. Allow 4 to 6 weeks for delivery. Outside U.S.A., payments must be drawn on U.S. banks, in U.S. dollars only

How To Curl Your Hair

Place ends of hair on roller and wind toward your scalp (Fig 1). Roll hair firmly and secure with clip. You can use either the metal clip (not included) or the Super Clip. When using the metal clip, secure the roller by placing the clip crosswise over the roller. When using the Super Clip, open the clip and place it on the roller so that when released the clip wraps around the rolled hair (Fig 2).
The firmness of the curl is regulated by the heat-up time and the length of time the roller is left in your hair.
For tight, firmer curls the rollers should be allowed to heat up longer. The rollers should be left in the hair for at least ten minutes before removing. For soft, curvy curls and waves, rollers should be removed from the hair after a shorter period of time.
IMPORTANT: After using the setter several times, you will find the best combination for your hair and the results you desire.
To remove roller, hold roller in one hand while removing clip with the other hand. Gently drop roller (do not pull) and let curl bounce
back after roller is completely removed. Let cool for one minute for a good set curl, and then style your hair into a style that lasts for
hours.

Styling Tips

For soft curls and waves, use one or two rollers on the top front layer of your hair. Use the remaining rollers on the sides and back of the head. The hair should be taken in equal sections and rolled under, toward your neck. After eight to ten minutes the rollers can be removed. Let hair cool for one minute and then style.

With short hair, use two rollers to roll the top front layer of your hair. Use the remaining three rollers to roll the sides and back of head.
Important: For best results with short hair, use the Super Clips in place of the metal clips.

MAINTENANCE

Your hair setter is designed for household use and is virtually maintenance- free. This product represents the highest standards of workmanship and engineering research.

If cleaning becomes necessary, disconnect the appliance from the power source. Allow the setter to cool. Clean the unit and the heating posts with a damp cloth. (Occasionally you may want to clean rollers. Use a damp cloth and mild detergent or soap.) If any abnormal
condition occurs, unplug the hair setter, allow it to cool, and return it to an authorized service representative for repair.

STORAGE

Allow hair setter to cool. Handle cord carefully for longer life; avoid jerking or straining at plug connections. Place hairsetter out of reach of children in a safe, dry location.

CONAIR TS7X Jumbo Roller Travel Hairsetter - WARNING

KEEP AWAY FROM WATER

Everyone knows that electricity and water are a dangerous combination. But did you know that an electric appliance is still electrically
live even if the switch is off? If the plug is in, the power is on. So when you are not using your appliances, keep them unplugged.

ALWAYS UNPLUG SMALL APPLIANCES

LIMITED ONE YEAR WARRANTY

Conair will repair or replace (at our option) your unit free of charge for 12 months from the date of purchase if the appliance is defective in workmanship or materials.

To obtain service under this warranty, return the defective product to the service center listed below, together with your purchase receipt and $3.00 for postage and handling. California residents need only provide proof of purchase and should call 1-800-366-0937 for shipping instructions. In the absence of a purchase receipt, the warranty period shall be 12 months from the date of manufacture.

ANY IMPLIED WARRANTIES, OBLIGATIONS, OR LIABILITIES, INCLUDING BUT NOT LIMITED TO THE IMPLIED WARRANTY OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, SHALL BE LIMITED IN DURATION TO THE 12-MONTH DURATION OF THIS WRITTEN, LIMITED WARRANTY. Some states
do not allow limitations on how long an implied warranty lasts, so the above limitations may not apply to you.
IN NO EVENT SHALL CONAIR BE LIABLE FOR ANY SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES FOR BREACH OF THIS OR ANY OTHER WARRANTY, EXPRESS OR IMPLIED, WHATSOEVER. Some states do not allow the exclusion or limitation of special, incidental, or consequential damages, so the above limitation may not apply to you.