COMARK RF400 WiFi Monitoring System User Guide
- June 6, 2024
- COMARK
Table of Contents
- Welcome ! Setting up your RF400 Logger
- Remove mounting bracket
- Remove battery cover
- Connect probe/s
- Install AA batteries
- Now you are set up and ready to monitor!
- Device Indication Overview
- Important safety information
- Sales and Technical Support
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
RF400
Cloud-connected
Data logging
QUICK START GUIDE
Welcome ! Setting up your RF400 Logger
Before you connect your RF400 data logger, you will need to complete the
following steps.
- Set up an account on www.comarkinstruments.net/software/44Cloud so that you can view your devices remotely.
- Download the Comark Cloud App on your phone or tablet
- Have your WiFi network details to hand
Remove mounting bracket
Remove battery cover
(Do not refit this until setup is complete)
Connect probe/s
Install AA batteries
6. In the Comark Cloud App, go to the menu, select Set Up Device and
follow the on-screen instructions
7. Once the RF400 data logger is connected to your WiFi network replace
the battery cover and install the RF400 data logger where it is to be used.
View and change device settings using the App or through your Comark Cloud
Account
Now you are set up and ready to monitor!
Device Indication Overview
visit Comark Cloudhttps://comark.wifisensorcloud.com/ and click Support for a detailed visual and sound state indication
| State | Front Button LED | Sounder |
|---|---|---|
| Device OK | 1 Flash / 5 Sec | No Sounder |
| Fault | 1 Flash / 5 Sec | Single-tone ring every 30 minutes |
| Alarm | 1 Flash / 5 Sec | Continuous two-tone ring |
Important safety information
WARNING: Failure to follow these safety instructions could result in
fire, electrical shock, other injury or damage.
Repairing or modifying
Never attempt to repair or modify this product. Dismantling may cause
damage that is not covered under the warranty. Servicing should only be
provided by an approved supplier. If the product has been punctured or
seriously damaged, do not use it and return it to an approved supplier.
Using connectors and ports
Never force a connector into a port. Check for obstruction in the port;
make sure that the connector matches the port and that you have positioned the
connector correctly in relation to the port. If the connector and port do not
join with reasonable ease, they probably do not match and should not be used.
Power Supply
Only use 1.5V AA batteries or a genuine RF420 power adapter to power your
RF400 data logger.
Disposal and recycling
You must dispose of this product and batteries according to relevant laws
and regulations. This product contains electronic components and therefore
must be disposed of separately from household waste.
Caution
Risk of explosion if the battery is replaced by an incorrect type. Dispose
of used batteries according to the instructions.
To access Declaration of Conformity information for RF400 products view:
www.comarkinstruments.com/documents
Sales and Technical Support
You can view FAQs, Help Guides and other support resources at
www.comarkinstruments.com
Comark Instruments
52 Hurricane Way
Norwich, Norfolk, NR6 6JB the United Kingdom Tel: +44 (0) 207 942 0712
Email: sales@comarkinstrumentsi.com
Comark Instruments
P.O. Box 500
Beaverton, 0R97077, USA Toll-Free: (800) 555 6658
Email: sales@comarkusa.com
© 2019 Comark Instruments
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>