anko Massage Belt with Heat CF-6006N User Manual

June 6, 2024
Anko

Massage Belt
with Heat
User Manual

anko Massage Belt with Heat CF-6006N

Model No.: CF-6006N
Rev 1
Note: The specifications and/or components of this appliance are subject to change without prior notice.

READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE

Warnings

Before using this appliance, read and follow all warnings and instructions in this manual, even if you are familiar with this product.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.

WARNING Only use the Power Supply that was provided with this appliance.
Model No. GQ24-120150- AA

Important Safeguards

Please read this instruction manual carefully before first use. It is advisable to keep this instruction manual for future reference.
DO NOT use this product as a substitute for medical attention.
DO NOT use this product for more than 30 minutes at a time. Allow at least 30 minutes cool down periods in between uses. Extensive use could lead to the appliance overheating and reduce the life of the product.
DO NOT leave the appliance unattended when in use or plugged in.
Take care that children cannot touch the appliance when in use, and make sure they cannot reach and pull the power cord.
To protect against the risk of electric shock, do not immerse the appliance, cord, or power supply in water or other liquids.
DO NOT use or store the product near sinks, baths, or showers containing water or near running water.
DO NOT use in the bath, shower, spa. pool etc.
Always disconnect the power supply from the PowerPoint after use.
DO NOT use if the power supply or power supply cord is damaged. It must be disposed of in order to avoid a hazard.
Use only accessories recommended or supplied by an authorized service center or qualified dealer. The use of accessories not intended for use with this appliance may cause injuries to the user or damage to the appliance.
The unattended use of heat by children or incapacitated persons may be dangerous.
This product is not to be used by very young children (0-3 years)
Children under the age of three are not to use this appliance due to their inability to react to overheating.
This product is not intended for medical use. It is intended only to provide a comfortable massage.
If you have any concerns regarding your health, consult your doctor before using this appliance.
Individuals with pacemakers should consult a physician before using this product.
In case of pregnancy, diabetes, or illness, consult your doctor before using this product.
Massage should be pleasant and comfortable. Should pain or discomfort result, or if you experience pain in a muscle or joint for a prolonged period of time, stop use and consult your doctor.
Never use any massager on the face, open wounds, discolored areas, areas of poor circulation, or any areas of the body that are swollen, burned, inflamed, or where skin eruptions or sores are present.
Never reach or touch an appliance that has fallen into the water. Unplug from the mains power point immediately.
Position the power supply cord properly so that it will not be walked on or pinched by items placed on or against it.
DO NOT store or use the appliance near or in high-temperature areas.
ONLY for indoor domestic use. Industrial or commercial use invalidates the warranty.
No liability can be accepted for any damage caused by non-compliance with these instructions or any other improper use or mishandling of the appliance.

IMPORTANT
If you have any concerns regarding your health, consult your doctor before using this appliance. Individuals with pacemakers should not use this product. If you experience pain in a muscle or joint for a prolonged period of time, discontinue use and consult your doctor. Persistent pain could be a symptom of a more serious condition.

Components

anko Massage Belt with Heat CF-6006N - Components

1 Massage Belt with Heat 4 Belt Extension
2 Controller 5 D.C. Output Plug
3 D.C. Input Socket 6 Power Supply: GQ24-120150- AA

Features

  • Built-in 4 vibration massage motors.
  • 3 pre-programmed massage modes.
  • 2 levels of vibration intensity.
  • Optional soothing heat therapy.
  • 30-minute Auto-Off timer.
  • Convenient Corded Remote controller

Operation Procedure

NOTE: This appliance will automatically turn off after approximately 30 minutes of operation.
Do Not use for more than 30 minutes at a time without a 30-minute cool-down period in between.
This should not be considered as a substitute for manually turning off your appliance. Always remember to turn off and unplug when not in use.
5.1 Power supply
Use only with Power Supply Model: GQ24-120150- AA
Before first use, please read this Instruction Manual carefully.
Insert the small plug end of the power supply into the small socket of the massager as shown.

anko Massage Belt with Heat CF-6006N - Power supplyPlug the power supply into the PowerPoint and switch it on.
The appliance is now ready for use.

5.2 Massager Controller

anko Massage Belt with Heat CF-6006N - Massager
Controller

  • On / Off Button: Press the On / Off Button to switch On and bring the controller out of Standby.
    The Indicator Light will illuminate.
    Press again and the controller will turn Off and go into standby.
    The indicator light will turn off.

  • Intensity Button: With the Controller switched on (out of standby), press this button and the Massager will start in default mode.

  • The indicator light will illuminate bright indicating it is at Maximum Intensity.

  • Press this button again, and the massage intensity will be lowered indicated by the indicator light dimming.
    Press the On / Off button to turn the massager off.

  • Mode Button (3 Modes): With the Controller switched on (out of standby), press this button and the Massager will start in default mode.

  • The Indicator light will illuminate.
    The Intensity indicator light will also illuminate bright indicating it is on Maximum Intensity.
    Press this button again, and the massager mode will change to a different vibration pattern and the indicator light will flash fast.
    Press this button again, and the massager mode will change to a different vibration pattern and the indicator light will flash slowly.
    Press again to turn it Off.
    Note: in any mode, you can press the Intensity Button to reduce the intensity.
    Press the On / Off button to turn the massager off

  • Heat Button: With the Controller switched on (out of standby), press this button and the Massager heater will start to heat on Maximum power.
    The Indicator Light will illuminate bright indicating it is on Maximum power.

  • Press this button again, and the Heater will reduce to Low power indicated by the indicator light dimming.
    Press this button again, the Heater will turn Off.
    Note: You may use this heat function whilst using the massager in any mode.
    Press the On / Off button to turn the massager off.
    Note: The massager / Heat will automatically turn off after approximately 30 minutes, or alternatively, you can manually turn it off before the 30 minutes has passed.

5.3 Massage Belt

To fit the massager belt, place the belt around your lower back, with the controller and power cables at the bottom, and the Quilted side of the fabric facing outward.
Bring the side tabs around to your front and secure them with the hook and loop fastener.
Should you require the belt to be longer, there is an extension piece supplied.
Secure the extension piece to one of the belt tabs and then bring the side tabs around to your front and secure with the hook and loop fastener.
You are now ready to use your Massager Belt with Heat.

Cleaning the Massager

CAUTION: DO NOT IMMERSE IN WATER OR LIQUID.

  • Turn off and unplug from the power supply prior to cleaning.
  • Do Not immerse the Massager or power supply in water, or any other liquid.
  • Spot Clean only with a soft, very slight damp sponge.
  • NEVER allow water or any other liquids to come into contact with the massager especially the power socket or and power supply.
  • Never use abrasive cleaners, solvents, steel wool, scouring pads, brushes, or strong chemicals that might or might not be flammable and/or damage to the product to clean.
    DO NOT place in a washing machine or dishwasher.

Completion and Storage

  • After you have finished using the massager, if need be, clean it as described under the Cleaning section, then store safely in its box and in a dry place.
  • Do Not wind the power supply cord around the massager or power supply body as this will damage the cord over time. Simply loop the cable and place it next to the power supply.

Troubleshooting

Problem

| Cause|

Remedy

---|---|---
| | Plug-in power supply and Switch On at PowerPoint.
| Power Not Switched On.| If still no power, check the PowerPoint has power supplied by checking with another appliance such as a table lamp.
No Power.| | If no power to the PowerPoint, call an electrician.
| Power supply is not plugged into the appliance.| Insert a small plug end on the Power supply into the appliance.
| Over Temperature protection device has been activated and turned off for your safety.| Unplug the power supply from the PowerPoint and allow the appliance to cool down for approximately 30 minutes before restarting.
No Massage / Vibration| Appliance not switched on.| Press the I/O (On/Off) button on the controller.
You have not pressed either the Intensity or Mode buttons.| Pressed either the Intensity or Mode button.
Vibration too Low / High| The Intensity is either set to Max or Min| ****

Press the Intensity button to select the required amount of vibration

| | Press the I/O (On/Off) button on the
Heat Function won’t| The controller is Off (Standby)| controller to bring the controller out of Standby, then press the Heat button
| ****

Press the Heat button.

operate| The Heat button has not been
| Pressed “On”
Appliance| The appliance has an auto-off|
turns off| the function which activates after| Allow the product to cool for at least
during| approximately 30 minutes of| 30 minutes and then turn on again.
use.| use.|

Warranty Against Defect
12 Month Warranty
Thank you for your purchase from Kmart.
Kmart Australia Ltd warrants your new product to be free from defects in materials and workmanship for the period stated above, from the date of purchase, provided that the product is used in accordance with accompanying recommendations or instructions where provided. This warranty is in addition to your rights under the Australian Consumer Law.
Kmart will provide you with your choice of a refund, repair, or exchange (where possible) for this product if it becomes defective within the warranty period. Kmart will bear the reasonable expense of claiming the warranty. This warranty will no longer apply where the defect is a result of alteration, accident, misuse, abuse, or neglect.
Please retain your receipt as proof of purchase and contact our Customer Service Centre 1800 124 125 (Australia) or 0800 945 995 (New Zealand) or alternatively, via Customer Help at Kmart.com.au for any difficulties with your product. Warranty claims and claims for expenses incurred in returning this product can be addressed to our Customer Service Centre at 690 Springvale Rd, Mulgrave Vic 3170.
Our goods come with guarantees that cannot be excluded under the
Australian Consumer Law. You are entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.

For New Zealand customers, this warranty is in addition to statutory rights observed under New Zealand legislation.

IMPORTANT!
For all technical queries or difficulties in operating the product and for spare parts, contact H.E. Group customer service 1300 105 888 (Australia) and 09 8870 447 (New Zealand).

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals