IKEA GENOMFRYSA Under Counter Freezer Instruction Manual
- June 6, 2024
- Ikea
Table of Contents
IKEA GENOMFRYSA Under Counter Freezer Instruction Manual
Package Content
Power ON/OFF
Safety Instruction
Product description
- Control panel
- Freezer drawers (freezing-In)
- Freezer drawer
- Rating plate
Freezer compartment
(marked with the symbol for storing fresh food, frozen food and making ice
cubes)
Characteristics, technical data and images may vary according to the model.
Accessories
-
Freezer block
-
Ice tray
-
Ice scraper
First use
Connect the appliance to the mains power supply. The ideal temperatures for preserving food have already been set at the factory (2-3/MED). To avoid food waste, please refer to the recommended setting and storage times found in the user manual.
Note: After switching the appliance on, it will be necessary to wait for 2 to 3 hours before a temperature suitable for a standard appliance load is reached.
Controls
- A. RED LED: indicates that the freezer temperature is too high (see “what to do if”)
- B. GREEN LED: indicates that the appliance is on
- C. Door contact switch
- Ca. Door contact switch for reset of acoustic alarm
- D. Thermostat.
Daily use
Operation of the freezer
The freezer can be used for storing already frozen food and for freezing fresh food. The amount of fresh food (in kg) that can be frozen in 24 hours is indicated on the appliance data plate. The freezer can operate at ambient temperatures between +10°C and +32°C. Optimal performance is obtained at temperatures between +16°C and +32°C.
Switching on the freezer for the first time
- There is no need to set the freezer temperature on the thermostat because the appliance is already factory set.
- Plug in the appliance. The green LED (indicating that the appliance is ON) and the red LED will light up, and on some models also the acoustic alarm (if provided) will sound after about 1 minute, indicating that the freezer has not yet reached a sufficiently cold temperature for storage of foodstuffs.
- To mute the acoustic alarm press the door switch.
Adjusting the thermostat
Select the freezer compartment temperature using the thermostat knob:
- 1 = Minimum freezing power
- 4 = Maximum freezing power
Ambient air temperature, the frequency of door opening and the amount of food
to freeze can affect the freezer temperature adjustments.
We therefore recommend starting with a medium temperature setting 2 – 3.
Function of LEDs
The green LED indicates whether the appliance is ON. The red LED indicates that the internal temperature of the appliance is not suitable for storing food.
Door alarm
If the door will be left open for more then 1 minute the alarm ring. Close the door or press for few seconds the botton C.
Installation
The appliance must be handled and installed by two or more persons – risk of injury. Use protective gloves to unpack and install – risk of cuts.
**** Installation, including water supply (if any), electrical connections and repairs must be carried out by a qualified technician. Do not repair or replace any part of the appliance unless specifically stated in the user manual. Keep children away from the installation site. After unpacking the appliance, make sure that it has not been damaged during transport. In the event of problems, contact the dealer or your nearest Aftersales Service. Once installed, packaging waste (plastic, styrofoam parts etc.) must be stored out of reach of children – risk of suffocation. The appliance must be disconnected from the power supply before any installation operation – risk of electric shock. During installation, make sure the appliance does not damage the power cable – risk of fire or electric shock. Only activate the appliance when the installation has been completed.
**** Be careful not to damage the floors (e.g. parquet) when moving the appliance. Install the appliance on a floor or support strong enough to take its weight and in a place suitable for its size. and use. Make sure the appliance is not near a heat source and that the four feet are stable and resting on the floor, adjusting them as required, and check that the appliance is perfectly level using a spirit level. Wait at least two hours before switching the appliance on, to ensure that the refrigerant circuit is fully efficient
**WARNING:** When positioning the appliance, ensure the supply cord is not trapped or damaged.
WARNING: To avoid a hazard due to instability, positioning or fixing of the appliance must be done in accordance with the manufacturer instructions. It’s forbidden to place the refrigerator in such way that the metal hose of gas stove, metal gas or water pipes, or electrical wires are in contact with the refrigerator back wall (condenser coil).
To guarantee adequate ventilation, leave a space on both sides and above the appliance. The distance between the rear of the appliance and the wall behind the appliance should be 50 mm, to avoid access to hot surfaces. A reduction of this space will increase the Energy consumption of product. Please remove the power cord from condenser hook during installation before connecting product to power supply
When contacting our Service Provider, please state the codes provided on your product’s identification plate. The model information can be retrieved using the QR-Code reported in the energy label. The label also includes the model identifier that can be used to consult the https://eprel.ec.europa.eu database portal.
Inspection check list
Please follow the inspection checklist before using your appliance. If any answer is NOT please follow the relevant action. Please remember to write down the product serial number and article number as required and attach your receipt to this page.
Product serial number (rating plate)| |
---|---|---
Product artical number (rating plate)| |
Purchasing date| |
| |
| If the answer is YES| Actions to do if NOT
Consideration Tray
Check that the tube is inside the tray
| No action| Put the tube inside the tray
Making sure gasket seals all around the door when the door is closed| No
action| Refer to the Al – door allignment step
Checking no collision between parts/forniture while opening/closing the
cooling door| No action| Refer to the Al – door allignment step
Secure the installation inside any kitchen system and fixed as required| No
action| Follow the Al for the proper installation
General information
The drawers, baskets and shelves should be kept in their current position unless otherwise specified in this quick guide. The light system inside the refrigerator compartment uses LED lights, allowing for better lighting than with traditional light bulbs, as well as for very low energy consumption. Doors and lids of the refrigeration appliance should be removed before disposal in the landfill, to avoid children or animals getting trapped inside
Technical data
| IKEA | GENOMFRYSA | 10 | 218 | 40 | F |
|---|---|---|---|---|---|
| Brand | Model | Freezing |
capacity
(kg/24h)| Energy
consumption
(kwh/year)| Noise level
(dba)| Energy class
To download the full version visitwww.ikea.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>