eKids 625 Series DJ Party Mixer User Manual

: June 6, 2024
: eKids

Table of Contents

Installing the Batteries
Recording Audio
Maintenance
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Model: 625 Series
DJ PARTY MIXER

Front View

Party Mixer Modes
There are three modes of play: Rhythm, SFX, and Speech. Press a mode button to start making music! When a mode is active, the respective button
will stay lit.

Sound Banks
Activate a soundbank by pressing FX Buttons 1-6. Try them all as you edit and mix your very own music!

Character Button: Press to activate BeatDrop!
Song Button: Press to play built-in music!
FX Buttons:
Press and hold for 2 seconds to loop when in SFX Mode!
Press and continue to hold to loop when in Speech Mode!
Tempo Switch: Slide up and down to change the tempo!
Turntable: Spin to trigger ‘DJ record scratch’ SFX!
Mic Button: Press and hold while you sing into the microphone!

This product bears the selective sorting symbol for waste electrical and electronic equipment (WEEE).
This means that this product must be handled pursuant to European Directive 2012/19/EU in order to be recycled or dismantled to minimize its impact on the environment.
For further information, please contact your local or regional authorities.
Electronic products not included in the selective sorting process are potentially dangerous for the environment and human health due to the presence of hazardous substances.

We, eKids, declare that this device complies with the essential requirements of the RED Directive 2014/53/EU.
EU Authorized Representative: BMD – 3 Boulevard des Bretonnieres, 49124 St Barthelemy d’Anjou, France

Installing the Batteries

Using a Phillips screwdriver, open the battery compartment door located on the back of the unit.
Insert 3 new AA (R6) batteries in the battery compartment. Make sure batteries match the + and – as indicated in the battery compartment diagram.
Replace the battery compartment door. Do not overtighten the screw.

Battery Use Cautions and Tips for Safety & Best Performance

Only use the recommended/supplied batteries or equivalent.
Rechargeable batteries are to be removed from the toy before being charged.
The supply terminals are not to be short-circuited.
Use alkaline batteries for longer life.
Do not mix old and new batteries, and do not mix alkaline, carbon-zinc or rechargeable nickel-cadmium batteries.
Insert batteries with proper polarity (+/–) as indicated.
Remove exhausted batteries from the product.
Recharge rechargeable batteries under adult supervision.
Do not attempt to recharge non-rechargeable batteries.
Do not open batteries or heat them beyond normal ambient temperatures.
To prevent battery leakage or damage remove batteries from a product if it will not be used for a month or longer.
Use extreme caution handling leaking batteries (avoid direct contact with eyes and skin). If battery leakage comes in contact with eyes, IMMEDIATELY flush the eye with lukewarm and gently flowing water for at least 30 minutes. If skin contact occurs, wash skin with clear water for at least 15 minutes. Seek medical attention if any symptoms occur.
Store in a cool, dry, ventilated area away from hazardous or combustible material.
Do not dispose of batteries in the household trash or fire.
Follow applicable laws and local regulations for the disposal and transportation of batteries.
Rechargeable batteries are to be removed from the toy before being charged.
The supply terminals are not to be short-circuited.
Do not dispose of batteries in the fire; batteries may leak or explode.
Batteries should be replaced by an adult.
Remove all packaging before giving it to your child.

Recording Audio

To Record And Store Up To One Minute of Audio:

Press and hold Record Button until the button flashes.
Any audio playing from the AUX jack, microphone, or built-in sounds will record.
Press and hold the Mic Button while you sing to record your voice.
Press the Record button again to stop recording. Press again to playback audio.

Note: The Record Button will stay lit when a recording is stored. Any new recording you make will overwrite the previously stored audio. Press and hold the Record Button for 5 seconds to erase the current recording.

Maintenance

It is important to keep the unit as dry and clean as possible. You may clean the cabinet with a cloth or sponge moistened with mild soap and water. Do not attempt to use strong cleansers or solvents, as they may cause damage.

EC Declaration of Conformit
Section 1
Product TROLLS 2 DJ TROLLEX PARTY MIXER
Model/type TR-625
Catalogue N/A number
Product Image

Manufacturer KID DESIGNS INC
Name &
1299, Main Street, Rahway, NJ 07065, U.S.A.
Address
Section 2
This declaration is issued under the sole responsibility of the manufacturer.
We hereby certify that the product stipulated above complies with all the relevant provisions of the following EC new approach directive/s:

2009/48/EC Toy safety
2014/30/EU Electromagnetic Compatibility (EMC)
2011/65/EU Annex II and its amendment (EU) 2015/863
Restriction of Hazardous Substances (RoHS)

KlDdesigns, Inc.

Section 3
Conformity is shown by compliance with the applicable requirements of the following harmonized standards:

Applicable Harmonized Standards (Standard reference, date, and amendments) e.g. EN71-1:2014| Notified Body (where applicable provide name and address of notified body) e.g. Bureau Veritas CPS Warrington, UK| Title
e.g. Safety of Toy: physical & mechanical
---|---|---
EN71-1: 2014+A1:2018| Seismic, Inc.| Safety of Toy: physical & mechanical
| California, USA|
EN71-2:2011 + A1:2014| Siemic, Inc.| Safety of Toy: Flammability
| California, USA|
EN71-3:2019| Siemic, Inc.| Safety of Toy: Migration of certain elements
| California, USA|
EN62115:2005 + Al2:2015| Seismic, Inc.| Safety of Electric Toys
| California, USA|
EN 55032: 2015-1-AC:2016| Seismic, Inc.| Electromagnetic compatibility
EN 55035:2017| California, USA|
(lEC 61000-4-2:2008,| |
IEC61000-4-| |
3:2006-1-A1:2007+A2:2010)| |