eKids PK-207.EXv24 Pokemon Toy Walkie Talkies User Manual
- May 15, 2024
- eKids
Table of Contents
eKids PK-207.EXv24 Pokemon Toy Walkie Talkies
Product Specifications
- Model: PK-207.EXv24
- Brand: FAR
- Design: GBX Design by Jay
- Age Recommendation: 3+
- Features: Easy Push-to-Talk Button, Static Free, Extended Range
- Effective Range: Up to 500 feet under ideal conditions
- Antenna Talk Button, Speaker, ON/OFF Switch, Microphone
- Manufactured by: eKids, LLC. Distributed at 1299 Main Street,
- Rahway, NJ 07065
Front PVC sheet
Back PVC sheet
Battery Installation
Note: Batteries should always be installed by an adult.
- Use a Phillips screwdriver to open the battery compartment door located on the back of the unit.
- Insert X XX (XXX) batteries into each Walkie Talkie with + and – terminals as indicated in the compartment.
- Replace the compartment door and tighten the screw with a Phillips screwdriver. Do not over-tighten the screw.
DON’T FORGET THE BATTERIES!
X x “XX” (XXX)
BATTERIES REQUIRED (NOT INCLUDED)
TM and character names are trademarks of Nintendo.
PK-207.EXv24
Distributed by eKids, LLC.
1299 Main Street, Rahway, NJ 07065.
MANUFACTURED IN CHINA. www.eKids.com
CONSUMER INFORMATION PRODUCT: Walkie Talkies.
AGE GRADE: Ages 3 and over.
WARRANTY
One-year limited warranty. Visit www.ekids.com/support for details. Valid only in the U.S.A.
CONTENTS
- Walkie Talkies.
- REQUIRES: 4 X “AAA” (R03) batteries (not included).
- Do not mix old and new batteries, and do not mix alkaline, carbon-zinc, or rechargeable nickel-cadmium batteries.
- Insert batteries with correct polarity (+/-) as indicated.
- Do not attempt to recharge non-rechargeable batteries.
- To prevent battery leakage or damage, remove batteries from the product if it will not be used for a month or longer.
- Use extreme caution when handling leaking batteries (avoid direct contact with eyes and skin).
- If battery leakage comes in contact with the eyes, IMMEDIATELY flush the eyes with gently flowing, lukewarm water for at least 30 minutes.
- If skin contact occurs, wash the skin with clean water for at least 15 minutes. Seek medical attention if any symptoms occur.
- Follow applicable laws and local regulations for the disposal and transportation of batteries.
- DO NOT DISPOSE OF BATTERIES IN A FIRE; BATTERIES MAY EXPLODE OR LEAK.
- Product specifications and colours may vary from photo.
- Packaging should be kept as it contains important information.
FCC Information
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, under Part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Release the preparation and return the equipment and receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This product meets the applicable Industry Canada technical specifications. This device complies with ISEDC license-exempt RSS standard(s). Operation is subject to the following two conditions: 1) this device may not cause interference, and (2) this device accepts interference, including interference that may cause undesired operation of the device. For body-worn operation, this model device has been tested and meets the FCC/ISED RF exposure guidelines when used with an accessory designated for this product or when used with an accessory that Contains no metal and that positions the face up minimum distance are 25 mm Any Changes or modification ons not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
WARNING: Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.
NOTE: All controls, adjustments and switches that are instructed in the
manual or follow-up instruction provided by the manufacturer may be operated
or adjusted without resulting in a violation of FCC rules.
WARNING: Any adjustment that could result in a violation of FCC rules and
recommended could be performed only by or under the immediate supervision and
responsibility of a person certified as technically qualified to perform
transmitter maintenance and repair duties in this radio service by an
organization or committee representative of users of that service.
Effective September 30, 2019, no person shall sell or offer for sale hand-held portable radio equipment capable of operating under FRS and any other licensed or licensed-by-rule radio services in CFR Title 47 Chapter I. Replacement of any transmitter component (crystal, semiconductor, etc.) not authorized by the IC/FCC equipment authorization for this radio could violate IC/FCC rules. Portable Radio Operation and RF Exposure Antenna Care Use only the supplied or approved replacement antenna. Unauthorized antennas, modifications, or attachments could damage the radio and may violate FCC/IC regulations. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. CAN ICES-3 (B)/NMB-3(B), CAN RSS-Gen/CNR-Gen.