Govee B6062101 Glide Wall Light User Guide
- June 6, 2024
- Govee
Table of Contents
Govee B6062101 Glide Wall Light
To Watch The Installation Video Tutorial
- Visit the Govee Glide Wall Light product page on store.govee.com
- Search “Govee Glide Wall Light” on Amazon or YouTube.
Caution
- Do not power on until you have assembled all segments.
- This product is ideally used on smooth surfaces (e.g. glass, wood, etc); not suitable for uneven, bumpy or wet surfaces (e.g. brick, stucco, etc).
- Keep the product away from water. If you need to clean it, please use a dry rag.
- Clean and ensure the surface is totally dry before sticking the product on.
In the Box
- 6x Segments (30cm each)
- 1x Corner Piece
- 1x Control Box and Input
- 1x Power Adapter
Before Installation
Step 1
Assemble the segments with the desired layout on a flat surface
Step 2
Connect the input to the end segment/corner piece. Then connect the control
box to the power adapter.
Step 3
Power on to check each segment is working. Next, power off, disassemble the
segments, and disconnect the control box.
Step 4
Plan the appropnate installation location in advance. Determine the
position of the outlket. it is recommended to place the control
Installation Steps
Step 1
Install the segments from the side farthest away from the adapter. When
installing, remove the protective film and push each segment firmly on the
wall for at least 30 seconds.
Step 2
After assembling all the segments, connect the input at the end of the control
box wire to the end segment and finally to the power adapter.
To Disassemble
Pull to detach the segments and then remove the adhesive tape from the wall.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>