Andesfit Wireless Non-contact Infrared Body / Surface Thermometer ADF-B38A User Guide
- June 6, 2024
- Andesfit
Table of Contents
Non-Contact Thermometer- Quick Start Guide
Wireless Non-contact Infrared
Body / Surface Thermometer
Quick Start Guide
Model # ADF-B38A
NOTES for using this thermometer
- Always make sure the thermometer is in BODY mode before taking a measurement. The light next to the word BODY should be lit to indicate it is in BODY MODE. If the light next to the word SURFACE is lit, press the “MODE” button to select BODY MODE.
- Store the thermometer in the room where you take your measurements. If you move the thermometer to a new room to take a measurement and the temperature in the new room is very different from where the thermometer was stored, the reading may not be accurate. Bring the patient to the thermometer, don’t bring the thermometer to the patient.
Installing the Batteries
New batteries were installed in your device before shipping. Unless instructed bya support person, skip this section
This product uses 2 AA batteries. Remove the battery cover and place the batteries according to the polarity diagram in the battery compartment.
Do not allow other people to use your thermometer. The thermometer is specifically assigned to you and you only. Allowing other people to use your thermometer can mislead your provider.
Taking a Measurement
-
Press and hold the “Power/Measure” trigger to turn on the thermometer.
-
The light next to the word BODY should be lit to indicate it is in BODY MODE. If the light next to the word SURFACE is lit, press the “MODE” button to select
BODY MODE. -
Point the head of the thermometer.5 inches to approximately 2 inches from the forehead.
-
Pull the “Power/Measure” trigger and release. The thermometer beeps when the reading is complete. The temperature displays in the LCD Viewing window.
-
The thermometer will turn off automatically in 1 minute.
-
The reading will automatically be transferred to the RCP SmartHub and then sent to your provider.
Understanding the Results
Your temperature will display on the LCD screen on the backside of the head of the thermometer.
The normal body temperature is 98.6 degrees Fahrenheit.
Non-Contact Thermometer- Quick Start Guide
V1.1
REMOTE CARE PARTNERS
Documents / Resources
|
Andesfit Wireless Non-contact Infrared Body / Surface Thermometer ADF-
B38A
[pdf] User Guide
Andesfit, Wireless, Non-contact, Infrared, Body, Surface, Thermometer, ADF-
B38A
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>