KRAMER Galil 6-AW 2-Way On-Wall Outdoor Speaker Instruction Manual
- June 6, 2024
- Kramer
Table of Contents
KRAMER Galil 6-AW 2-Way On-Wall Outdoor Speaker
Galil 6-AW Quick Start Guide
This guide helps you install and use your Galil 6-AW for the first time.
Go to
www.kramerav.com/downloads/Galil6-AW
to download the latest user manual and check if firmware upgrades are
available.
Check what’s in the box
- Galil 6-AW All Weather Speakers
- 2 mounting U-brackets
- 4 knobs
- 4 mounting screws
- 2 grommets
- 1 Quick start guide
- 1 User manual
Get to know your Galil 6-AW
| # | Feature | Function |
|---|---|---|
| 1 | Speaker Grille | Protects the internal components of the speaker from |
foreign objects. Do not remove the grille from the speakers.
2| Tweeter| Emits high frequency sounds.
3| Woofer Driver| Emits low frequency sounds.
4| Keyhole Mounting Point| Use to attach the U-bracket to a wall.
5| U-Bracket| Use to mount the speaker onto a wall (allowing left/right
rotation).
6| U-Bracket knobs (2×2)| Use to fasten the U-bracket to the speaker (two
knobs per bracket).
7| Input and Output Terminal Block Connectors| One +, – pair for the input and
one +, – pair to output to the next speaker in an array configuration.
8| Tap Selector| Adjust each speaker to the appropriate tap setting:
For 70V: select 3.7W, 7.5W, 15W, or 30W; For 100V: select 7.5W, 15W, or 30W.
Alternatively, select 8W to bypass the transformer when connecting directly to an amplifier without using the 70/100V array option.
9| Protective Cover| Protects speaker cables and tap selector.
10| Cable Gland/Grommet| Pass the speaker cable through the cable
gland/grommet to protect the connectors from outdoor weather conditions.
Choose the best location
Before installing the speakers:
- Experiment by placing the speakers in different locations before finally deciding on the most suitable location.
- Be sure that the wall type is appropriate for the mounting U-brackets, that is, either solid wood, bricks, concrete, hollow building blocks, or wood studs.
- Check that the mounting location is free of obstructions, such as electrical piping, AC ducts or water lines, and so on.
Install the Galil 6-AW
Always switch OFF the power on each device before connecting it to your Galil
6-AW.
To connect the Galil 6-AW to the amplifier:
-
Cut the dual color cable wires to similar lengths, leaving some excess wire to easily remove the speakers from the U-brackets.
For outdoor installations you need to use weatherproof cables. -
Adjust the tap setting.
-
Connect the wires to the appropriate terminal block connectors on the speaker.
-
Mount the grommet/cable gland on the protective cover and pass the cables through the grommet/cable gland and the protective cover.
-
Close the tap selector and connector opening with the protective cover.
-
Connect the mounting U-brackets.
-
Connect the wires to the amplifier (left speaker wires to amplifier “L” terminal blocks and right speaker to amplifier “R” terminal blocks.
The following diagram displays the Galil 6-AW speakers connected to a
recommended Kramer power amplifier
(for example, PA-120Z):
For optimum range and performance use the recommended Kramer cables available at www.kramerav.com/product/Galil6-AW. Using third-party cables may cause damage!
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>