anko Low Voltage 4ft Santa Inflatable User Manual

: June 6, 2024
: Anko

Table of Contents

Installation instructions:
Assembly diagram:
Adaptor Manual
Documents / Resources
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)

LOW VOLTAGE 4FT SANTA INFLATABLE

These instructions are for your safety. Please read through them thoroughly before use and retain for future reference.

Before You Start

Decide on an appropriate location for your product (see Installation instructions below).
If you have any doubt about installing this product, consult a qualified electrician.

Installation instructions:

This inflatable product is suitable for INDOOR AND OUTDOOR USE.
The AC adaptor MUST be installed INDOORS away from the weather.
Do not position or place near heaters or any other direct sources of heat.
This product is suitable for positioning on surfaces that have normal flammability, e.g. wood, plasterboard, masonry.
However, this does not include highly flammable surfaces (e.g. polystyrene, textiles).
Always position cables and extension leads so that they will not be a hazard to the elderly, pets, and children.
DO NOT position this inflatable product where it may become covered by other items e.g. curtains, nets, or bedding.
Ensure the unit is positioned so that you have enough cable to reach an indoor mains power socket.

Warning

This inflatable product is suitable for INDOOR AND OUTDOOR USE.
This product is NOT designed for permanent or long-term use.
The AC adaptor MUST be installed INDOORS away from the weather.
The supplied adaptor is suitable for the operation of LED Modules only.
Only operate this light set with the supplied adaptor, Model No. JT-DC12V9W-F3
Do not connect this inflatable product electrically to another inflatable product.
Do not connect this inflatable product to the power supply while it is in the packaging.
DO NOT attempt to replace the non-replaceable bulbs in this inflatable product.
Never allow any part of the set to come into contact with a source of heat or flame.
Care must be taken to avoid damage to the cable or fittings.
If any part of a light set or cable is damaged, the light set MUST be discarded.
This product is for use as decoration only. Not to be used by children as a toy. Keep out of reach of children.
Do not position this inflatable product where it will be exposed to extreme wet weather or submerged in water.
Always switch off this light set or unplug an adaptor if unattended.
DO NOT overload power sockets or extension leads.
DO NOT pierce the cable when securing in place, bend or stand on the standing light, as this will damage the bulbs or wiring.
Please refer to the packing or product rating label for a product class, specifications, and rating.

Assembly diagram:

LED Bulbs
This inflatable product is constructed with non-replaceable bulbs. DO NOT attempt to replace any of the bulbs in the light set.
Keycode: 43069835

Adaptor Manual

Do not open the cover of the equipment.
The power supply is suitable for LED modules.
The input and output voltage should be checked before use to ensure correct use.
This is the Class II product, JT-DC12V9W-F3 is only for indoor use.
The product is not a toy, keep it where children can not reach it.
The lamp controller does not rely upon the luminaire enclosure for protection against accidental contact with live parts.
The adaptor is for socket mounted only. Not for Recess Use.
The minimum clearance distance from the top and sides of the controller to normally flammable building elements is 225 mm and 300 mm.
The minimum clearance distance from the top and sides of the controller to normally flammable building elements.
If the minimum clearance distances from each side of the controller are different, or there are different minimum clearance distances for various types of normally flammable building elements or building insulation, then each minimum clearance distance shall be stated separately.
Where the controller is required to be mounted on a specific surface or has additional installation requirements, for example, use in non-combustible enclosed space or to ensure adequate sealing to maintain its IP rating, the relevant information shall be supplied with the controller