A BF SS-305MP Mini DC Regulated Power Supply Instruction Manual

A BF SS-305MP Mini DC Regulated Power Supply Instruction Manual

Product description

Specification

| Output Voltage Range| Output Current Range
---|---|---
30V/5A| 0-32V| 0-5A
30V/10A| 0-32V| 0—10A

Rated Operating Conditions

Working voltage: check the body label
Working conditions : temperature 0 40 ”C, relative
humidity: 680% RH
Storage conditions : temperature -20 60
relative humidity: 180% RH
The whole temperature range to en9ure accuracy. 23 ”C a 5 ”C

Specification

Panel Features

1. Voltage value display mater

2. Current value display meter

3. Power value display meter

4. Switch button for Output

5. Power switch

6. CV stable voltage indicator, whtch is on under stable voltage working status

7. CC stable current indicator, which is an under stable current working status

8. Key lock indicator. Long press of the current value knob to unlock / lock the button, with the indicator lights up to lock. Only the OUTPUT button works when the button is locked.

9. Voltage setout knob for output stable voltage value : Press the knob to enter the setting mode. As the digits flash, rotate the knob clockwiee to increase the output voltage, and counterclockwise to decrease the output voltage. Pressing the knob will change the digit bit of dashing digits. Long press of the knob to stare the state of switch an/off , which will take effect at the next boot

10. Current lock for output stable current value: Press the knob to enter the setting mode. As the digits flash, rotate the knob clockwise to increase the output current, and counterclockwise to decrea Be the output current. Long press of the knob will change the digit bit of flashing digits. Press and hold the knob to unlock / lock the keys.

11. Output terminal positive (red)

12. Output terminal negative (black)

Rear Panel

1. Cooling fan
2. Input socket for supply voltage
3. Fuse holder
   

Instructions for use and protective measures

1. Keep the switch oP. Connect the power cable of the power supply. Ensure the L end of the power cable plug connected to the live wire of the power socket and the grounding wire connected to the ground.

2. The power supply must be grounded when in use.

3. Pleaee attach importanoe to good ventilation when in use.
   Keep a 10cm gap with other articles from four sides of the power supply. Do not expose the power supply to dusty, corrosive gas and other harmful substanoes.

4. Specification of the power supply should be measured after 15 minutee of itsWarming-up”.

5. Ensure the transfer switch for voltage input consistent with the mains electricity prior to power connection, otherwise this will lead to serious failure.

Packing List

1. 1 * Mini Regulated DC Power Supply
2. 1 * Power Cable
3. 1 * User’s Manual
4. 1 ” Testing L

Maintenance

1. With normal power supply voltage, the failure of digital display after the power is on may due to the burning out of the fuse or other faults. Then replace the fuse or ask for professional’s help after disconnecting the power switch and unplugging the power cable.
2. When the stable voltage source is used, the power supply will automatically switch to the stable current working state as the output voltage is less than the desired value with the CC light on for current protection. The load should be checked or the maximum current should be increased in this situation (to adjust CURRENT clockwise).
3. When the stable current source is used, the power supply will automatically switch to the stable voltage working state as the output current is less than the desired value with the CV Tight on for voltage protection. The load should be checked or the maximum voltage should be increased in this situation (to adjust VOLTAGE clockwise).
4. Please contact your dealer or our company if the fault is serious and cannot be resolved.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>