global sources QF-211 Solar Motion Sensor Wall Light User Manual
- June 6, 2024
- global sources
Table of Contents
global sources QF-211 Solar Motion Sensor Wall Light User Manual
Introduction
The solar lamp can automatically detect surrounding brightness: during the
day, it enters the charging mode and converts sunlight into electricity and
stores it in the built-in battery. The lamp lights up automatically at night.
It has three modes, you can set the desired lighting mode with the switch
button on the back or remote control
Features
- Waterproof
- Heat Resistance
- Frost Resistance
- PIR Motion Sensor
- 113LEDs
- Three Modes
Package Contains
-
Solar Lamp
-
Mounting Bracket
-
Screw
-
Plastic Wall Plug
-
Remote Control
-
Manual
Operating Guide
Operation guide Please turn on the power switch on the back of the product C) before using it, for lighting mode selection, please press the switch button -1‘-, Mode 1—Mode 2—Mode 3 as follows:
When using the remote control, please take out the plastic spacer, and it
should be operated toward the receiving hole that above the sensor. When the
mode switched successfully, the light flashes twice.
Mode 1: T he lamp lights up when people come to it and goes out when
people leave. When motion is detected by the PIR sensor, the lamp will be
high light mode, after working for 22 seconds, it will automatically turn off,
then enter the standby state.
Mode 2: T he lamp lights up when people come to it and becomes dim
when people leave. When motion is detected by the PIR sensor, the lamp will
be high light mode, after working for 22 seconds, it will automatically switch
to dim light, then enter the standby state.
Mode 3: Steady light. Continuous low light mode, PIR sensing function is
off. after lighting for 4hrs, it will automatically switch to Mode 1.
Installation
Use the crews and plastic wall plugs to install the mounting bracket on the
wall, then fix the solar lamp on the mounting bracket. Adjust the irradiation
direction of the solar panel, and pay attention to not having shade to block
the solar panel, the longer the solar panel is exposed to sunlight, the longer
the lighting time will be. Adjust the three spotlights’ irradiation angle or
direction to achieve the best lighting effect.
THANKS FOR READING! If you have any questions about our product, please feel free to contact us.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>