Chroma-Q CHSPFV Space Force Protective Lens Kit User Guide
- June 6, 2024
- Chroma-Q
Table of Contents
Quick Start Guide
Chroma-Q® Space ForceTM
Protective Lens Kit
For a full product manual please visit
www.chroma-q.com
Part Number: CHSPFPL, CQ647-9080, CQ1512-9080
Model: 650-9080, 647-9080, 1512-9080
For use with
Part Number: CHSPF[XXXX], CQ647-XXXX, CQ1512-XXXX
Model: 650-XXXX, 647-XXXX, 1512-XXXX
Space Force TM Protective Lens Kit QSG V2.0
QSG P/N: 650-0910
Overview
The Chroma-Q® Space Force™ Protective Lens Kit protects the expensive diffuser from scratches, fingerprints, dirt. For a complete list of accessories please visit www.chroma-q.com.
Kit Contents
| Items | Model | Qty |
|---|---|---|
| Protective Lens Acrylic | 650-0208, 647-0601, 1512-0512 | 1 |
| * Screw M3x10 Ultra-Low HH Zn | 430-1310-2 | 8 |
- Available in only 650-9080 Kit (for Space Force™ octo, NOT included in 647-9080 (for Space Force onebytwo™ ) or 1512-9080 (for Space Force twobyfour™). Use the same screws that are installed in the Space Force onebytwo™ and Space Force twobyfour™ light fixtures.
Tools Required
Torx T6 x 70mm Screwdriver (maximum torque: 0.62nm/5.5in‐lb.)
Procedure
-
Place the light fixture horizontally on a clean rigid surface.
-
Remove the screws that hold Diffuser and Protective Lens
i. For Space Force™ octo: Remove the existing 8 – M3x8 Ultra-Low Torx Screws from Space Force™ unit using Torx T6 x 70mm screwdriver. These screws will not be needed anymore.
ii. For Space Force onebytwo™ and twobyfour™: Remove the M3x10 Ultra-Low Torx Screws from Space Force™ unit using Torx T6 x 70mm screwdriver. Keep them in a secure location. These screws will be used to install the new protective lens. -
If a Protective Lens was already installed, remove the old Protective Lens. Keep the Space Force™ Diffuser Lens as it is; align the new Protective Lens to match the retaining screw holes.
-
Install the M3x10 ULTRA LOW HH ZN screws using a Torx T6 x 70mm screwdriver.
Note : DO NOT tighten the screws with high torque. This might damage the ProtectiveLens and/or the threads of the stand-off. -
Further Information
Please refer to the Chroma-Q® Space Force™ manual for more detailed information. A copy of the manual can be found at the Chroma-Q® website – www.chroma-q.com/support/downloads
Approvals & Disclaimer
The information contained herein is offered in good faith and is believed to
be accurate. However, because conditions and methods of use of our products
are beyond our control, this information should not be used in substitution
for customer’s tests to ensure that Chroma-Q® products are safe, effective,
and fully satisfactory for the intended nd use. Suggestions of use shall not
be taken as inducements to infringe any patent. Chroma-Q® sole warranty is
that the product will meet the Chroma-Q® sales specifications in effect at the
time of shipment. Your exclusive remedy for breach of such warranty is limited
to refund of purchase price or replacement of any product shown to be other
than as warranted.
Chroma-Q® reserves the right to change or make alterations to devices and
their functionality without notice due to ongoing research and development.
The Chroma-Q® Space Force™ has been designed specifically for the lighting
industry. Regular maintenance should be performed to ensure that the products
perform well in the entertainment environment.
If you experience any difficulties with any Chroma-Q® products please contact
your selling dealer. If your selling dealer is unable to help, please contact
[email protected]. If the selling dealer is
unable to satisfy your servicing needs, please contact the following for full
factory service:
Outside North America:
Tel: +44 (0)1494 446000
Fax: +44 (0)1494 461024
[email protected]| North America:
Tel: +1 416-255-9494
Fax: +1 416-255-3514
[email protected]
---|---
For further information please visit the Chroma-Q® website at www.chroma-q.com.
Chroma-Q® is a trademark, for more information on this visit www.chroma-q.com/trademarks.
The rights and ownership of all trademarks are recognized
Space Force™ Protective Lens Kit QSG V2.0
QSG P/N: 650-0910