BRESSER Smartphone Holder Instruction Manual
- June 6, 2024
- BRESSER
Table of Contents
Smartphone Holder
for 1/4″ connection thread
INSTRUCTION MANUAL
GENE RAL WARNINGS
DANGER OF MATERIAL DAMAGE!
Only use this product as an accessory on devices with the appropriate
technical requirements.
When installing, make sure to secure the clamps well to avoid dropping your
smartphone.
The manufacturer accepts no liability for damage to the device itself or to
alternative devices (optics, smartphones, etc.) caused by improper handling.
SCOPE OF DELIVERY (Fig. 1 )
Smartphone holder (1 pc.)
ASSEMBLY EXAMPLES
TECHNICAL DATA
Designation Mounting type:
Smartphone Adaptor horizontally or vertically via 1/4″ female thread on
devices with corresponding 1/4″ male thread (e.g. photo tripod, telescope
device, or similar)
GENERAL ASSEMBLY INSTRUCTIONS
Check whether the technical requirements for mounting this accessory on the
desired device are met.
Before assembly, remove all accessories from the packaging and check for
completeness.
ASSEMBLY
- (Fig. 2 + 2a) Place holder in the desired position on existing base with 1/4″ thread (1) and screw on (2).
- ( Fig. 3) Pull out the clamp (3), push in the smartphone 1) (4), and retract the clamp (5).
Contact
Bresser GmbH
Gutenbergstr. 2
46414 Rhede – Germany
@BresserEurope
- Smartphone not included. / Errors and technical changes excepted. / Manual_Smartphone-Holder-Messier_en_BRESSER_v012021a
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>