MIGRO Smart Wi-Fi Controller Installation Guide
- June 6, 2024
- MIGRO
Table of Contents
Smart Wi-Fi Controller
INSTALLATION MANUAL
Part #: MEU-2PWF
- Read important safety information below before beginning installation
- Open Outer Cover by releasing the cover latch
- Install the Conduit Fitting provided (or one provided by others) in the desired location ensuring wire clearance within the enclosure
- Install the Antenna provided on to the threaded connector located on the outside of the enclosure.
- Place the Smart Box in the desired location and use the supplied hard-ware to secure firmly.
- Wire in accordance with the national and local electrical codes (see wiring diagram below).
- Close outer Cover.
- Smart Box is now ready to be connected to the Wi-Fi router via the app.
For MANUAL OVERRIDE Momentarily press the small BLACK but ton located on the white Sonoff smart WiFi switch module.
WIRING DIAGRAM:
240VAC Application
Contactor Load Ratings
- Normally Open
- 50 A. Incandescent or Resistive Load AC1
- 40 A. Ballast and General Purpose AC3
- 10HP @240V, 15KW 277VAC
- 40 A. Ballast 7 KW@ 220VAC
- UL Rated
- NEMA Standards
Sample Use Case Diagram
240VAC Application
Refer to eWelink Instructions for App connectivity
WARNING: This Smart Box system should be installed by a LICENSED
ELECTRICIAN. Turn Power off at main panel before servicing this switch or the
equipment it controls.
Wiring must be in accordance with all national and local electrical code
requirements This Smart Box Enclosure does not provide grounding between
conduit connectors. When metal conduit is used, wires and bushings must be in
accordance with NEC requirements.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>