ergotron 33-397-085 WorkFit-T Standing Desk Converter User Guide
- June 6, 2024
- ERGOTRON
Table of Contents
WorkFir™-T
Standing Desk Converter
User Guide
Tools Needed
2 person lift.
Yup, that’s it. Really.
Now your WorkFit-T is ready for however you work best.
Ready to get moving on an active workstyle? Check out www.ergotron.com/tips to
get started.
Learn more about ergonomic computer use at: www.ergotron.com/ergonomics
Important Information.
Safety
Minimum Desk Size:
Weight Capacity:
CAUTION: DO NOT EXCEED THE MAXIMUM LISTED WEIGHT CAPACITY. SERIOUS INJURY OR PROPERTY DAMAGE MAY OCCUR!
WARNING
PINCH POINT
DO NOT place hands on or near support bars. Pinch points are created during
lifting and lowering the work surface. Failure to follow these instructions
may result in serious personal injury.
Warning: Because mounting surface materials can vary widely, it is imperative that you make sure the mounting surface is strong enough to handle mounted products and equipment.
Warning: Impact Hazard! Worksurface under tension. Moving Parts can Crush and Cut. Raise this product to its full-up position before lifting it off the desk. Two people are required to lift this product off the desk. Do not tip this product on its side or upside down. This product must remain upright at all times. Failure to heed this warning may cause unintended motion of the lift mechanism resulting in possible serious personal injury and or property damage!
Caution: Raise worksurface slowly. Raising worksurface too fast may create an unstable situation resulting in property damage and or personal injury.
Caution: To avoid the potential to pinch cables it is important to follow the cable routing instructions in this manual. Failure to follow these instructions may result in equipment damage or personal injury.
Caution: Keep monitor and laptop base fully on the work surface. Allowing any part of the base or stand to hang off the edge may result in property damage and or personal injury.
For the latest User Installation Guide please visit:
www.ergotron.com
For Warranty visit:
www.ergotron.com/warranty
For Service visit: www.ergotron.com
For local customer care phone numbers visit: http://contact.ergotron.com
NOTE: When contacting customer service, reference the serial number.
www.ergotron.com
USA: 1-800-888-8458
Europe: +31 (0)33-45 45 600
China: 400-120-3051
Japan: japansupport@ergotron.com
© 2018 Ergotron, Inc. All rights reserved. WorkFitTM is a registered trademark
of Ergotron, Inc.
While Ergotron, Inc. makes every effort to provide accurate and complete
information on the installation and use of its products, it will not be held
liable for any editorial errors or omissions (including those made in the
process of translation from English to another language), or for incidental,
special or consequential damages of any nature resulting from furnishing this
instruction and performance of equipment in connection with this instruction.
Ergotron, Inc. reserves the right to make changes in the product design and/or
product documentation without notification to its users. For the most current
product information, or to know if this document is available in languages
other than those herein, please contact Ergotron. No part of this publication
may be reproduced, stored in a retrieval system, or transmitted in any form or
by any means, electronic, mechanical, photocopying, recording, or otherwise
without the prior written consent of Ergotron, Inc.,1181 Trapp Road, Eagan,
Minnesota, 55121, USA Patents Pending and Patented U.S. & Foreign. Ergotron is
a registered trademark of Ergotron, Inc.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>