3DSIMO BASIC 2 Instructions
- June 6, 2024
- 3DSIMO
Table of Contents
3DSIMO – BASIC 2
INSTRUCTION MANUAL
Charge your device before first use
controls and elements
service cover access
ADULT SUPERVISION
you can easily maintain your 3DSIMO Basic 2
1. open service cover with service key
2. remove all ground material and dust, then put the cover back onto Basic 2
insertion of material
Turn on the Basic 2. The device is fully preheated once the LED bar is full.
Insert material into filament opening. Once you feel pressure, go to another step
hold the extrusion button and check if your material is fed into the nozzle. After a while, you will see material going out of the nozzle.
ejection of material
press retraction button and wait until the LED bar is off repeat this step three times.
Pull out the material. If you feel tension, press the retraction button again. keep in mind, that ejection of material is possible only when the device is preheated.
charging
Plug the Micro USB cable into the charging port.
Check that the LED bar shows charging sequential status.
Once the charging is done, the LED bar shows you, that the charging process is
done.
If the charging sequence does not start after connecting the charging cable,
the cable must be disconnected and the device must be switched off and on
several times.
charging done
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>