AP360-2FFP 2 Gallon 360 Aquarium with Power Filter and LED Lighting Instructions
- June 6, 2024
- AQUARIUM
Table of Contents
AP360-2FFP 2 Gallon 360 Aquarium with Power Filter and LED Lighting
Your Aquarium
People of all ages enjoy looking at aquariums. Aside from the belief that an aquarium is beautiful, many also believe owning an aquarium can be relaxing, rewarding and a great conversation piece all at the same time. You will find you will have many enjoyable hours with your new aquarium and fish.
Included in your Aquarium Kit
- 2G Fish Tank
- Full Hood
- LED Light
- Power Filter
- Filter Cartridge
Power filter uses Koller Products® XS replacement filter cartridge (AQ05FC-60)
Important Instructions
Read This Section before operating this unit. For Household Use Only. Confirm your tank has not been damaged during shipping before you start the setup process. Completely install aquarium before operating. The LED unit is powered by 3 AAA batteries or by Koller Products Power Adapter 5V-AQ51000, neither are included in this kit. To avoid the unit plug or receptacle from getting wet, position the tank and stand to one side of a wall mounted receptacle to prevent water from dripping onto it.
A “Drip Loop” should be made as shown at right.
Tank Placement
Leave enough space in back of the aquarium to allow easy access to the filter and various electrical cords from the electrical equipment.
Good places for your aquarium
On a table or aquarium stand that’s capable of bearing the weight of your filled aquarium.
Places to avoid
- Near direct sources of sunlight (e.g. windows), unwanted algae growth may occur.
- Near direct sources of heat or air conditioning (e.g. radiator, forced air vent).
- Around sources of noise (e.g. stereo speakers, TV).
- Drafty areas.
- Do not place aquarium on any good surface that can be damaged by water. Where water can come in contact with other electrical appliances.
Rinsing Gravel and Decor
Rinse aquarium, filter, stones, plastic plants, and other decorations under running tap water. Place gravel in a colander or new bucket and rinse under running tap water until water runs clear. Never clean aquarium, decorations, or filter with household soaps as they can harm your fish.
*Gravel and Decorations not included with aquarium kit
Battery Requirements
TIMER SELECTION SWITCH with 3 settings you can select:
- Continuous On
- 2 Hour Duration (2H)
- 4 Hour Duration (4H
WARNING :
- Do not mix old and new batteries.
- Do not mix Alkaline, Standard or Rechargeable Batteries.
- LED light uses 3 AAA batteries.
*It’s recommended to use this setting sparingly in order to conserve battery power unless using USB connector or optional AQ51000 5V Power Adapter.
LED Light
- To turn on LED light press the blue button switch on top of the light.
- Continue to press the blue button until desired color is located.
- 7 colors to select from:
Daylight White, Blue, Green, Red, Aqua, Purple, and Amber.
Optional (not included):
Koller Products Power Supply 5V 1A (model AQ51000) available online, enables
LED light to operate without batteries. Insert Micro-B connector into back of
LED light port and opposite end of USB cord connector into power supply .
Adding Water
Fill the aquarium with water to within two inches from the top of the tank.
Treat water with a tap water conditioner to remove chlorine and chloramines
from tap water that can be harmful to your fish. Confirm water temperature in
aquarium has reached room temperature before adding fish.
Installing Power Filter
Locate the adjustable hanger bracket inside the box. Place the hanger bracket
at 90° and align one of the adjustment holes onto the mounting post, rotating
it upwards until hanger is vertical. Install the filter inside the aquarium by
hanging the filter onto the aquarium rim. The water level of the filled
aquarium should be above the line on the front of the housing. To raise or
lower the Filter adjust the hanger by rotating the hanger 90º, remove it, and
replace it in an alternate alignment hole.
Optional Heater
Select proper sized heater appropriate for your aquarium size. Read and follow
the heater’s instructions. Check with your retailer for recommended heater
settings. Adjust heater settings as directed. Confirm water temperature with
thermometer. Always use a power strip with surge protector to safeguard your
electrical equipment.
Ongoing Maintenance
Perform a 25% water change monthly, more frequently if necessary depending on
number of fish and amount of daily feedings, use a vacuum gravel cleaner to
thoroughly remove any uneaten food and waste buildup.
To keep filter running efficiently replace Koller Products XS cartridge every
3 to 4 weeks, depending on the number of fish and amount of daily feedings, or
when reduced filter flow.
Test pH, ammonia and nitrite weekly. Performing these tests will allow you to
monitor the water quality of your aquarium. If readings are not in the
preferred range, perform a partial water change.
LED LIGHT FCC COMPLIANT
FCC Verification Tested Certificate Of Conformity # PRSZ17072812E
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this device.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
LIMITED WARRANTY
KOLLER PRODUCTS LLC warrants this aquarium product to be free from defects in
material and workmanship under normal use and service and according to the
provisions as specified in the accompanying assembly and operating
instructions, for a period of 1 year from date of purchase.
This warranty does not cover and KOLLER PRODUCTS LLC is not liable for the
cost of repair or replacement of parts which have been subject to misuse,
negligence, accident, improper installation, damage during shipment or
handling, normal deterioration due to wear and exposure or defects caused by
unauthorized parts or modification.
UNDER NO CIRCUMSTANCES WILL KOLLER PRODUCTS LLC BE LIABLE FOR ACCIDENTAL OR
CONSEQUENTIAL DAMAGES, INCLUDING BUT NOT LIMITED TO LOSS OF PROPERTY OR
EQUIPMENT.
Some states do not allow the exclusion or limitation of incidental or
consequential damages, or limitation on how long an implied warranty lasts, so
the above limitations or exclusions may not apply to you. This warranty gives
you the legal rights, which vary from state to state.
WARRANTY HELP REPLACEMENT PARTS
OR
TECH SUPPORT
IF ANY COMPONENTS ARE
DAMAGED OR MISSING
DO NOT RETURN TO RETAILER
PLEASE CONTACT
customercare@kollerproducts.com
800-545-1344
Manufactured by KOLLER PRODUCTS Shawnee, KS 66218 USA
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>