VOICE CADDIE SL2 Active Hybrid GPS Laser Rangefinder User Manual
- June 6, 2024
- VOICE CADDIE
Table of Contents
USER MANUAL
Detailed instructions on this product are available from VOICE CADDIE website.
www.voicecaddie.com
How to Use
- Color may change from dark-colored clothes or leather accessories.
- Wipe off any dirt immediately.
- Keep out from contact with water.
- When battery level is low, residual battery level [ ] blinks on the laser LCD display. In this case, only the laser functions are available.
- When the residual battery level indicator changes to [ ], the device may be turned off and inoperable.
- Please use only the dedicated USB charging cable with a C-type USB port.
- Please activate GPS in a space without obstacles such as roofs and trees (e.g. starting plaza).
- Reset: To reset, press, and hold the Power and Mode buttons for more than 6 seconds.
Components
Device, Pouch, USB Cable, User Manual
Device Details
① Laser Receiving Lens/Objective Lens
② Laser Transmitting Lens
③ Mode Button
④ Power Button/Measurement Button
⑤ Eyepiece and Focusing Unit
⑥ USB Charging Terminal
⑦ LCD Touchscreen Display
⑧ GPS Receiver
⑨ Tournament Mode Laser Measurement Indicator
Basic Functions
Quick Start Guide
-
Power On
Press to activate laser and GPS functions. -
Mode Selection
After turning the power on, press the M button to toggle in the following sequence: Normal Mode-> Pin Mode and->Tournament Normal Mode-> Tournament Pin Mode -
Unit Conversion
When the M button is pressed twice, the unit will toggle between meters (M) and yards (Y). -
Focus Adjustment Rotate the focus adjustment of the eyepiece to the left and right to adjust focus.
LCD Brightness
Press and together to adjust brightness in 1 to 6 steps. You can check the brightness level on the numerical laser LCD display.
LCD Brightness
Press and M together to adjust brightness in 1 to 6 steps. You can check
the brightness level on the numerical laser LCD display.
Laser LCD Display
① GPS Signal
② Measuring Mode Normal Mode Pin Mode
③ Slope Indicator Uphill Downhill
④ Distance Compensated Tournament Mode: Actual distance
⑤ Unit of Measurement Y Yards M Meters
⑥ Pin Mode
⑦ Scan Function
⑧ Laser Operation Indicator
⑨ Slope
⑩ Linear Distance
⑪ Battery Low Mark
Mode Guidelines
▶Slope Mode
NORMAL
– This mode provides distance compensated to the target position, linear
distance, slope guidance, and continuous measurement (scanning).
– SCAN: You can continuously measure the target while pressing the button.
PIN – GPS Pin Assist
– This mode measures the slope compensated distance, linear distance, and
slope to the pin.
– Pin on the green is accurately and quickly measured based on GPS data
– GPS pin assist blocks out the back of green based on GPS data and assists to
measure only the pin on the green.
▶Tournament Mode
NORMAL
– This mode measures only the linear distance for the pin measurement and scanning functions. – Press and hold the button converts to scanning function.
PIN Mode
– Actual distance from user position to pin
How to Use GPS Golf Mode
Turn On
Pressing the button activates the laser and GPS function..
Display
– Touching and sliding to the left and right toggles the guidance display.
Display Specifications
SMART COUSEVIEW™
Course Preview
– Course preview shows the course layout from tee box to green.
USER IP
– Check the Remaining distance with a touch from the target location and pin
– If the user moves, the distance remaining from the current position to the
pin is displayed.
BK/ HZ Distance
– Touch BK/HZ
– Easy to touch on the zoom screen
Driver Distance Arc
– When User Set up their own driver distance in Setting, the Driver distance
Arc shows up on Course View.
Smart Green View ™
Real Green Undulation
– Green contour lines are divided into 11 steps with 15cm intervals to
provide more precise green undulation.
Active Green View
– User location is recognized to automatically convert the green direction
Green Attack Info
– Green Attack Info shows The Length and Width of Greens and Back Green safe distance
Pin Re-Load
– User can Move the Pin on Green by this mode
Note
This equipment has been tested and found to comply with
The limits for a Class B digital device, pursuant to part 15 of the FCC
Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Note
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio / TV technician for help.
- This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
- Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.
- The device has been evaluated to meet general RF exposure requirements.
- The device can be used in portable exposure conditions without restriction
- Risk of explosion if the battery is replaced by an incorrect type.
Dispose of used batteries according to the instructions.
Caution
- This device may be affected by the weather and surrounding climates such as rain and cloud.
- Battery consumption may vary depending on the user environment and frequency of use.
- Aiming the laser directly at the human eye or gazing at the sunlight or bright light through this device may damage eyesight
- The lens, which is coated, needs cautions in cleaning, and should not be directly touched with a finger or rough material to prevent damage
- The device may be damaged from liquid or other substances. Avoid using in a wet environment, and wipe off immediately any dirt.
- Be careful not to drop, throw, insert impurities or arbitrarily modify by dismantling or burning the device
- Regularly recharge the device so that the battery is not fully depleted. Fully depleting the battery may shorten the battery lifetime.
- Gradual aging and performance degradation from normal use is not grounds for warranty.
Specifications
(1yard=0.91m)
Product | Voice Caddie SL2 |
---|---|
Dimensions / Weight | H 40.5 x V 77.4 x L 108.7mm / 222g |
Measurement Range | 5 -1,100 Y |
Tolerance | Laser: ±1 Y / GPS: ±3 Y |
Power & Battery | Over 5V/1A, Lithium-polymer 1,000mAh |
USB / Bluetooth | USB 2.0 / BT 5.0 |
Battery Charging | Approx 90 Minutes |
Battery Duration | Approx 45 Hours |
Manufacturer | VC Inc. / Made in China |
Importer / Distributor | VC Inc. |
Product Warranty
- This device has been produced under strict quality control and inspection process and is subject to consumer’s lawful compensation to damage according to the consumer damage compensation regulation by the Ministry of Finance and Economy.
- Free repairs within the warranty period are available in case of a problem with the product under normal conditions of use.
- Repairs at cost are available in case of a problem with the product due to user negligence even within the warranty period or after the warranty period.
- For after-sales service or compensation for damage, please produce this warranty card and receipt (bill) of purchase.
Product | Voice Caddie SL2 |
---|---|
Serial No. | |
Date of Purchase | |
Seller | |
Seller Contact | |
Buyer Name and Contact | |
Warranty Period | 1 year from purchase (Or 6 months for other components) |
Replacement and Return Period | 30 days from purchase date |
Customer Center
Responsible Party – U.S Contact Information
Street Address : 13951 Valley View Ave
City, State: La Mirada, CA Postal Code: 90638 Country: United States
Telephone Number: 562-926-3978
Internet Contact Information:
Support@voicecaddie.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>