VOICE CADDIE SL2 Active Hybrid GPS Laser Rangefinder with Green Undulation User Manual
- June 5, 2024
- VOICE CADDIE
Table of Contents
- VOICE CADDIE SL2 Active Hybrid GPS Laser Rangefinder with Green
- How to Use
- Components
- Device Details
- Basic Functions
- Laser LCD Display
- Mode Guidelines
- How to Use GPS Golf Mode
- SMART COUSEVIEW ™
- Specifications
- Product Warranty
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
VOICE CADDIE SL2 Active Hybrid GPS Laser Rangefinder with Green
Undulation
How to Use
- Color may change from dark colored clothes or leather accessories.
- Wipe off any dirt immediately.
- keep out from contact of water.
- When battery level is low, residual battery level [ ] blinks on the laser LCD display. In this case, only the laser functions are available.
- When the residual battery level indicator changes to [ ], the device may be turned off and inoperable.
- Please use only the dedicated USB charging cable with a C-type USB port.
- Please activate GPS in a space without obstacles such as roofs and trees (e.g. starting plaza).
- Reset: To reset, press and hold the Power and Mode buttons for more than 6 seconds.
Components
Device, Pouch, USB Cable, User Manual
Device Details
- Laser Receiving Lens / Objective Lens
- Laser Transmitting Lens
- Mode Button
- Power Button / Measurement Button
- Eyepiece and Focusing Unit
- USB Charging Terminal
- LCD Touchscreen Display
- GPS Receiver
- Tournament Mode Laser Measurement Indicator
Basic Functions
Quick Start Guide
- Power On Press to activate laser and GPS functions.
- Mode Selection After turning the power on, press the button to toggle in the following sequence: Normal Mode-> Pin Mode and->Tournament Normal Mode-> Tournament Pin Mode
- Unit Conversion When the button is pressed twice, the unit will toggle between meters (M) and yards (Y).
- Focus Adjustment Rotate the focus adjustment of the eyepiece to the left and right to adjust focus.
LCD Brightness
Press and together to adjust brightness in 1 to 6 steps. You can check
brightness level on the numerical laser LCD display.
Laser LCD Display
- GPS Signal
- asuring Mode Normal Mode Pin Mode
- lope Indicator Uphill Downhill
- Distance Compensated Tournament Mode : Actual distance
- Unit of Measurement Yards Meters
- Pin Mode
- Scan Function
- Laser Operation Indicator
- Slope
- Linear Distance
- Battery Low Mark
Mode Guidelines
Slope Mode
NORMAL
- This mode provides distance compensated to the target position, linear distance, slope guidance and continuous measurement (scanning).
- SCAN: You can continuously measure the target while pressing the button.
PIN – GPS Pin Assist
- This mode measures the slope compensated distance, linear distance and slope to the pin.
- Pin on the green is accurately and quickly measured based on GPS data
- GPS pin assist blocks out the back of green based on GPS data and assists to measure only the pin on green.
NORMAL
- This mode measures only the linear distance for the pin measurement and scanning functions.
- Press and holding the button converts to scanning function.
PIN Mode
- Actual distance from user position to pin
How to Use GPS Golf Mode
Turn On
Display Specifications
SMART COUSEVIEW ™
Course Preview
BK/ HZ Distance
Real Green Undulation
Note
This equipment has been tested and found to comply with The limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio / TV technician for help. \
- This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
- Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.
- The device has been evaluated to meet general RF exposure requirement.
- The device can be used in portable exposure condition with out restriction
- Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to the instructions.
Caution
- This device may be affected by the weather and surrounding climate such as rain and cloud.
- Battery consumption may vary depending on user environment and frequency of use.
- Aiming the laser directly to human eye or gazing at the sunlight or bright light through this device may damage eyesight
- The lens, which is coated, needs cautions in cleaning, and should not be directly touched with finger or rough material to prevent damage
- The device may be damaged from liquid or other substances. Avoid using in wet environment, and wipe off immediately any dirt.
- Be careful not to drop, throw, insert impurities or arbitrarily modify by dismantling or burning the device
- Regularly recharge the device so that the battery is not fully depleted. Fully depleting the battery may shorten the battery lifetime.
- Gradual aging and performance degradation from normal use are not grounds for warranty.
Specifications
Product Warranty
- This device has been produced under strict quality control and inspection process, and is subject to consumer’s lawful compensation to damage according to the consumer damage compensation regulation by the Ministry of Finance and Economy.
- Free repairs within the warranty period are available in case of a problem with the product under normal conditions of use.
- Repairs at cost are available in case of a problem with the product due to user negligence even within warranty period or after warranty period.
- For after-sales service or compensation to damage, please produce this warranty card and receipt (bill) of purchase.
Customer Center
Responsible Party – U.S Contact Information Street Address : 13951 Valley View
Ave City, State : La Mirada, CA Postal Code : 90638 Country : United
StatesTelephone Number : 562-926-3978
Internet Contact Information :
Support@voicecaddie.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>