ring 4SC2S9-0EN0 Smoke and CO Listener Z-Wave User Manual
- June 6, 2024
- Ring
Table of Contents
ring 4SC2S9-0EN0 Smoke and CO Listener Z-Wave
Instructions to locate Z-Wave DSK/QR code
Follow Device inclusion instructions provided in Ring Alarm mobile applications to locate QR code and enter PIN Code
Factory Reset Instructions
Press and hold the Setup button for 10 seconds. When the LED ring stops
blinking, Listener will reset. This process disconnects the Listener from Ring
Alarm. To begin using the Listener again, repeat the setup process in the Ring
app. “Use this procedure only in the event that the network primary controller
is missing or
otherwise inoperable.”
Association CC
This sensor has one Association groups of 1 node. Group 1 is the lifeline group who will receive unsolicited messages relating to Smoke/CO Siren detected/not detected notifications, case tampering notifications, and low- battery notifications.
| Parameter No. | Description | Size in Bytes | Value description | Default |
|---|
1
| Configures how often the sensor should send an unso- licited
Battery Report to the Lifeline.
|
2
| 255 to 4200 seconds in 255 second increments that the sensor should wait be- tween sending unsolicited battery reports.|
4200
2
| Configures the sensor to be able or not able to “hear” CO Detectors in addition to
Smoke Detectors.
|
1
|
1: Smoke Detector Siren
2: Smoke+CO Detector Siren
|
1
3| Starts the “Installation Test”
Mode
| 1| 0: Cancel Installation Test Mode
1: Start Installation TestMode
| 0
To review your warranty coverage, please visit www.ring.com/warranty
© 2020 Ring LLC or its affiliates.
Ring, Always Home, and all related logos are trademarks of Ring LLC or its
affiliates.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>