ring Flood & Freeze Senso Z-Wave User Manual
- June 6, 2024
- Ring
Table of Contents
Flood & Freeze Senso Z-Wave
Technical Manual
Instructions to locate Z-Wave DSK/QR code
Follow Device inclusion instructions provided in Ring Alarm mobile applications to locate QR code and enter PIN Code
Factory Reset Instructions
Press and hold the Setup button for 10 seconds. When the LED ring stops
blinking, Listener will reset.
This process disconnects the Listener from Ring Alarm. To begin using the
Listener again, repeat the setup process in the Ring app.
“Use this procedure only in the event that the network primary controller is
missing or otherwise inoperable.”
Association CC:
This sensor has one Association group of 1 node. Group 1 is the lifeline group that will receive unsolicited messages relating to Smoke/CO Siren detected/not detected notifications, case tampering notifications, and low-battery notifications.
Parameter No.| Description| Number of Bytes| Default|
Minimum| Maximum
---|---|---|---|---|---
1| Heartbeats:
This parameter is the number of seconds
heartbeats. Heartbeats are automatic battery reports on a timer after the last
event.| 2| 4200 (0x1068)| 255 (0xFF)| 4200 (0x1068)
2| One-shot timer:
Writing to this parameter prompts the sensor to send a wakeup notification one
time after this parameter’s number of seconds. After which it is reset back to
O.| 2| 0| 1| 32767 (0x7FFF)
3| A number of application-level retries of messages either not ACKed or
messages encapsulated via supervision get that did not receive a report.| 1|
5| 0| 5
To review your warranty coverage, please visit
www.ring.com/warranty.
© 2020 Ring LLC or its affiliates.
Ring, Always Home, and all related logos are trademarks of Ring LLC or its
affiliates.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>