saco WIDXL102 Indesit Washer Dryer Instruction Manual

saco WIDXL102 Indesit Washer Dryer

Control Panel

Starting a wash cycle

1. Switch the washer-dryer on by pressing the ON/OFF button. All LEDS will light up for a few seconds, the ON/OFF/Door Lock LED will begin to flash.
2. Load laundry and close door.
3. Set the programme knob to the desired programme.
4. Set washing temperature.
5. Set drying cycle if necessary.
6. Measure out the detergent and washing additives.
7. Start the programme by pressing the Start/Reset button for one second. Once the programme has been accepted all of the option and status LED’s will illuminate momentarily, the door lock LED will be lit and the relevant wash cycle progress LED will also be lit. To cancel it, keep the Start/Reset button pressed for at least 2 seconds.
8. When the programme is finished, the On-Off/Door lock LED will flash to indicate that the appliance door can be opened. Take out your laundry and leave the appliance door ajar to allow the drum to dry thoroughly. Turn the washer-dryer off by pressing the on/off button.

Table of wash cycles

Setting the temperature

Turn the temperature knob to set the wash temperature. The temperature can be lowered, or even set to a cold wash.

Set the drying cycle

Turn the drying knob to set the desired drying type. Two options are available:
A: Based on time from 40 minutes to 150
B: Based on the damp level of the dry clothes
Iron: Slightly damp clothes, easy to iron.
Hanger: Dry clothes to put away,
Cupboard: Very dry clothes recommended for towelling and bathrobes.
A cooling stage is foreseen at the end of the drying cycle.

Table of drying times

Dry only

Turn the programme knob to one of the drying settings (7-8) depending on the type of fabric, then select the desired drying type using the drying knob.

Functions

To enable a function:

1. Press the button corresponding to the desired function, according to the table below
2. The function is enabled when the corresponding button is illuminated.
   (The rapid flashing of the button indicates that the corresponding function cannot be selected for the programme set).

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>