Lasko CC23630 Revolution Full-Room Heater with Digital Remote Control Instruction Manual
- June 6, 2024
- Lasko
Table of Contents
Lasko CC23630 Revolution Full-Room Heater with Digital Remote Control Instruction Manual
www.lasko.com/product-registration/
Have a Question? Need a Part?
Please Do Not Return Product to Store! Contact Lasko Customer Service:
800-233-0268 Monday-Friday 8AM – 5PM
EST. (Valid in the USA, its Territories, and CANADA Only)
NEW 6/21
READ AND SAVE THESE INSTRUCTIONS
Read carefully before attempting to assemble, install, operate or maintain the
product described. Protect yourself and others by observing all safety
information. Failure to comply with instructions could result in personal
injury and/or property damage! This Heater is intended for use as supplemental
heat. This Heater is for residential use only. It is not intended to be used
in commercial, industrial or agricultural settings.
- Always place the Heater on a stable, flat, level surface when operating, to avoid the chance of the Heater overturning. Locate the Power Cord so the Heater or other objects are not resting on it. DO NOT run Power Cord under carpeting. DO NOT cover Power Cord with throw rugs, runners, or similar coverings as this may cause cord to overheat. Arrange Power Cord away from room traffic and where it will not be tripped over.
- This Heater is HOT when in use. To avoid burns, do not let bare skin touch hot surfaces. Always use handle when moving this Heater. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes and curtains at least 3 feet (0.9 m) from the front of the Heater and keep them at least 1 foot (0.3 m) from the sides and rear.
- This Heater is not intended for use in wet or damp locations. This Heater is not intended for use in bathrooms, laundry areas and similar indoor locations. NEVER locate a Heater where it may fall into a bathtub or other water container.
- DO NOT use Heater outdoors.
- This Heater is not suitable for use in agricultural facilities including areas where livestock, poultry or other animals are confined. Please refer to National Electric Code (NEC) Article 547-7 (2008), or applicable state or local codes or standards relating to electrical requirements for Agricultural Buildings. THIS Heater DOES NOT MEET THE REQUIREMENTS OF NEC ARTICLE 547-7 (2008).
- This Heater is not suitable for use in hazardous locations. Please refer to National Electric Code (NEC) Article 500 or applicable state or local codes or standards relating to electrical requirements for Hazardous locations. THIS Heater DOES NOT MEET THE REQUIREMENTS OF NEC ARTICLE 500 (2008).
- Remote controls for other appliances or electronic equipment can sometimes interfere with the operation of this Heater. If this occurs, move the Heater to another location.
- Keep Heater remote control unit away from chairs and your bed where it may be sat or laid upon and inadvertently turn on the Heater.
SAVE THESE INSTRUCTIONS
Parts Includes
Clean Filter
Controls
AUTO ECO™ THERMOSTAT
Pressing the ( + ) or ( – ) buttons while in any Heater function or speed will turn on the Auto Eco™ function.
-
To set the room at a specific temperature press the ( + ) or ( – ) buttons to the desired temperature. The temperature will be flashing on the display. The Unit is now in Auto Eco™ Mode.
-
When you reach the temperature at which you want to set the unit, the set temperature will flash several times and then the display will return to indicate the current room temperature and will gradually change as the room temperature changes.
NOTE: the temperature display does not indicate the temperature of the heated air being emitted by the Unit. -
Heater will run on HIGH heat when the ambient temperature is less than the set temperature.
-
Heater will run on LOW heat when ambient temperature reaches set temperature and will continue to run on LOW heat until ambient temperature reaches 2 degrees Fahrenheit above set temperature.
-
Heater will turn OFF once the ambient temperature is greater than 2 degrees Fahrenheit above set temperature. The fan will continue to run for 15 seconds after the heater element is turned off.
All of this happens automatically with Laski Auto Eco™ Technology. To deactivate the Auto Eco™ function, turn the Unit off or press the button. NOTE: In Auto Eco™, the Unit will display the current room temperature in Fahrenheit. Press the ( + ) and ( – ) buttons at the same time to change the display to ° Celsius. Press the same two buttons together again to change the display back to ° Fahrenheit.
AUTO-DIMMING DIGITAL DISPLAY
After 10 seconds the lights on the display will automatically dim. Touching any button will reillumination the lights to 100%.
REMOTE CONTROL
All the functions performed with the Remote Control work identically to the manual controls.
- Install two “AAA” batteries (included).
- Do not mix old and new batteries. Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries.
- DO NOT DISPOSE OF BATTERIES IN FIRE. BATTERIES MAY EXPLODE OR LEAK.
- Always purchase the correct size and grade of battery most suitable for the intended use.
- Replace all batteries of a set at the same time.
- Clean the battery contacts and also those of the device prior to battery installation.
- Ensure the batteries are installed correctly with regards to polarity (+ and -).
- Remove batteries from equipment that is not to be used for an extended period of time.
- Remove used batteries promptly. If you lose your remote control, please call Customer Service to order a replacement at 800-233-0268, Monday through Friday, between the hours of 8:00 a.m. and 5:00 p.m. EST.
SAFETY FEATURE
- A Tip-Over Switch is built in to prevent operation if the Heater is tipped over.
- A thermal overload protector is built in to prevent overheating.
- If an overheat temperature is reached, the Heater will automatically shut off. It can only resume operation when the user resets the unit. To
Reset Heater:
- Unplug the Heater and wait 10 minutes for the Heater to cool down.
- After the Heater has cooled down, plug the unit into a 120V~ electrical outlet and follow the operation instructions described in this manual.
TROUBLE SHOOTING TIPS
If your Heater shuts off unexpectedly or fails to operate, the previously mentioned safety feature may have been activated to prevent overheating.
- Be sure the power cord is plugged into a working electrical outlet.
- Make certain the batteries in the remote control are new and properly installed.
- Check your Temperature setting. The Heater may be off because it has reached the desired temperature setting.
- If your Heater runs for several minutes and shuts off repeatedly, your Heater may require cleaning. See Maintenance section below.
SERVICING: For servicing, other than general user maintenance, please contact Customer Service at 800-233-0268, Monday through Friday, from 8am-5pm Eastern.
STORAGE: Store the Heater with these instructions in the original carton in a cool, dry place.
DISPOSITION: Corrugated packaging materials are recyclable. For environmentally responsible disposal of this product, contact your local waste service provider or visit www.1800recycling.com ®.
MAINTENANCE
WARNING To reduce the risk of electrical shock and fire please observe the following instructions. Cleaning the Heater regularly will help to maintain its efficiency.
– Always unplug the cord before moving, servicing or cleaning.
– NEVER place the Heater in or near water. DO NOT IMMERSE HEATER IN WATER.
– Clean the Heater only with a vacuum equipped with a brush attachment; the
vacuum will remove the lint and dirt from the surface of the Heater.
– Vacuum intake grills every two weeks; this will help to maintain the optimum
Heater performance.
– Use a toothbrush or other soft bristle brush to gently loosen any dirt not
removed by the vacuum.
– NEVER attempt to take apart the Heater.
– Clean the body of the Heater with a soft cloth only.
– NEVER use ALCOHOL or SOLVENTS such as gasoline, benzene, paint thinner, or
other harsh cleaners.
LASKO PRODUCTS, LLC LIMITED WARRANTY (VALID IN THE USA, ITS TERRITORIES,
AND CANADA ONLY)
WHAT THIS WARRANTY COVERS: This product is warranted against defects in
workmanship and/or materials.
HOW LONG THIS WARRANTY LASTS: This warranty extends only to the original
purchaser of the product and lasts for three (3) years from the date of
original purchase or until the original purchaser of the product sells or
transfers the product, whichever first occurs.
WHAT LASKO WILL DO: Lasko will, at its sole option, repair or replace any
part or parts that prove to be defective or replace the whole product with the
same or comparable model. For all warranty claims, the product must be
returned to Lasko Products, LLC at customer expense with proof of purchase
within the warranty period. Contact the Lasko customer service department to
obtain a Return Authorization (“RA”). DO NOT return products without an RA or
the warranty claim will not be processed.
WHAT THIS WARRANTY DOES NOT COVER: This warranty does not apply if the
product was damaged or failed because of accident, improper handling or
operation, shipping damage, abuse, misuse, unauthorized repairs made or
attempted, or the use of the product for commercial or non-residential
service. This warranty does not cover shipping costs for the return of
products to Lasko for repair or replacement. Lasko will pay return shipping
charges from Lasko following warranty repairs or replacement. ANY AND ALL
WARRANTIES, EXPRESSED OR IMPLIED (INCLUDING, WITHOUT LIMITATION, ANY IMPLIED
WARRANTY OF MERCHANTABILITY), LAST THREE YEARS FROM THE DATE OF ORIGINAL
PURCHASE OR UNTIL THE ORIGINAL PURCHASER OF THE PRODUCT SELLS OR TRANSFERS THE
PRODUCT, WHICHEVER FIRST OCCURS AND IN NO EVENT SHALL LASKO’S LIABILITY UNDER
ANY EXPRESS OR IMPLIED WARRANTY INCLUDE (I) INCIDENTAL OR CONSEQUENTIAL
DAMAGES FROM ANY CAUSE WHATSOEVER, OR (II) REPLACEMENT OR REPAIR OF ANY HOUSE
FUSES, CIRCUIT BREAKERS OR RECEPTACLES. NOTWITHSTANDING ANYTHING TO THE
CONTRARY, IN NO EVENT SHALL LASKO’S LIABILITY UNDER ANY EXPRESS OR IMPLIED
WARRANTY EXCEED THE PURCHASE PRICE OF THE PRODUCT AND ANY SUCH LIABILITY SHALL
TERMINATE UPON THE EXPIRATION OF THE WARRANTY PERIOD. Some states and
provinces do not allow limitations on how long an implied warranty lasts, or
the exclusion or limitation of incidental or consequential damages, so these
exclusions or limitations may not apply to you. This warranty gives you
specific legal rights. You may also have other rights which vary from state to
state and province to province. Proof of purchase is required before a
warranty claim will be accepted.
CUSTOMER SERVICE:
Toll-Free 800-233-0268. Email:
producthelp@lasko.com Our Customer Service
team is available to assist you with product and service questions, and
replacement parts. They can be reached Monday through Friday,
8am-5pm Eastern. Please have your model number available, as well as the type
and style (located on the underside of your product). Customer Service Dept.,
820 Lincoln Ave., West Chester, PA 19380 (Please do not send product to this
location) www.lasko.com
PARTS FOR DISCONTINUED, OBSOLETE AND CERTAIN OTHER PRODUCTS MAY NOT BE AVAILABLE. DUE TO SAFETY REASONS, MANY ELECTRONIC COMPONENTS AND MOST HEATER COMPONENTS ARE NOT AVAILABLE TO CONSUMERS FOR INSTALLATION OR REPLACEMENT.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>