Razor W15130640030 Pocket Mod Motor Installation Guide
- June 6, 2024
- Razor
Table of Contents
Razor W15130640030 Pocket Mod Motor Installation Guide
Required Tools: (Not included)
A. Phillips head screwdriver
B. Flat head screwdriver
C. 5 mm Allen wrench
WARNING
CAUTION: To avoid potential shock or other injury, turn power switch OFF
and disconnect charger before removing or installing the batteries. Failure to
follow these steps
in the correct order may cause irreparable damage.
Step 1
Open the seat compartment. Using a Phillips screwdriver remove the four (4)
screws on the seat assembly. The locations of the screws are circled in the
image below. Remove the seat and set aside.
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday – Friday 8:00am – 5:00pm Pacific Time.
Step 2
Using a Phillips screwdriver, remove the three (3) screws from the front seat
cover. The locations of the screws are circled in the image below. Disconnect
the wires from the power switch and charger port. Remove front seat cover and
set aside. Locate and disconnect the motor connector.
Step 3
Using a Phillips screwdriver, remove the five (5) screws on the chain guard.
The locations of the screws are circled in the image below. Remove chain guard
and set aside.
Step 4
Using a flat head screwdriver, remove the spring from the tensioner arm to
loosen the tension on the chain.
Step 5
Turn the Pocket Mod on its side. Using a 5mm Allen wrench, remove the four (4)
hex screws that hold the motor onto the frame.
Step 6
Reverse the steps to install.
ATTENTION: Charge battery 12 hours before using.
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday – Friday 8:00am – 5:00pm Pacific Time.
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>