JIEHUA Car Bluetooth Device User Manual
- June 6, 2024
- JIEHUA
Table of Contents
User’s Manual
Product introduction ：
This Bluetooth Product is compliant with Bluetooth 5.1 Bluetooth Low Energy
System Suitable for digital transparent transmission Product picture：
Steps for usage：
The magnet is attached to the crank and is directly opposite to the arrow of
the Bluetooth box, see the picture below
- Pull out the black insulating sheet of the Bluetooth device, at this time, the red light of the Bluetooth device flashes once in 1 second to indicate that it is turned on
- Turn on the Bluetooth of the mobile phone and open the corresponding APP, the mobile APP will automatically pair with the Bluetooth box. After the pairing is successful, the red light of the Bluetooth device will flash once every 5 seconds.
- The magnet is swiped across the corresponding position in the middle of the Bluetooth device, and the Bluetooth device instantly transparently transmits data information to the mobile APP.
Note: The magnet cannot be swept across from the beginning to the end
between the two screws of the Bluetooth box, which may cause inaccurate
transmission data.
4 When the Bluetooth device is used for more than 3 months, or the Bluetooth
device is disconnected, the battery can be replaced How to replace the battery
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:(1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Any changes or
modifications not expressly approved by the party responsible or compliance
could void the user’s authority to operate the equipment. This equipment has
been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following
measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirements. The
device can be used in portable exposure conditions without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>