King-Serry Electronics KS-SF22R Motorbike/Bicycle Anti-Theft Alarm User Manual
- June 6, 2024
- King-Serry Electronics
Table of Contents
King-Serry Electronics KS-SF22R Motorbike/Bicycle Anti-Theft Alarm User
Manual
KS-SF22R
FCC ID:2ANPS-KS-WL09C
This device complies w ith Part 15 of the FC C Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
NOTE 2: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
- External: Domineering power with tiger form styling and acts a safeguard device to motorbike or bicycle.
- Similar performance to motorbike alarm, 113dB loud speaker although install at a hiding place to frighten the thief/robber.
- Use triaxial accelerometer sensor and special calculation to increase accuracy of robber manner recognition and reduce false alarms caused by noise interference.
- High efficient with 7 adjustable level of sensitivity, from soft touch to push beat and suitable for all conditions.
- 3 ringtones for remote bell sound；long range remote and easy to search the motorbike/bicycle.
- Can trigger SOS function and emit call for help automatically when an accident is occurred to provide more safeguard manner.
- Wireless remote operation; more simple and convenient to use.
- External Cover : PC material; IP55 water & dust proof
- Double-sided tape installation method is convenient for all types of motorbikes and bicycles.
1. External Structure Figure
Cautions:
- Pay attention on host fixation method suitability, double-sided tape or cable tie when use it.
- Install at a hiding location may reduce host alarm sound leve l.
- Do not install the host at surrounded with metal parts locati on.
Remote control have two below types according to order package set
2. Installation Guides
2.1 Host battery replacement and installation
2.1.1. Factory will install the battery by default. If the battery
requires a replacement or installs new batteries, please follows below figures
method by open bottom cover, install 3 pcs AAA alkaline battery.
The host produce 3 times short ‘Bi’ sound and indicates turn on and use the host directly; Recommend disassemble the battery if it does not use for long period of time。
2.1.2. It is recommended to avoid installation in locations where exposed to long-term and high-temperature sunlight. Too high temperature will accelerate battery self-discharge and shorten battery life. Please replace the battery in time when the battery is low, otherwise there is a risk of liquid leakage and damage to the host。
Dismantle bottom cover method figure ：
Remove the host’s 1pc bottom screw and use minus (-) screwdriver to open bottom cover by rotate or turn around. After open the bottom cover, continue to open side of the cover until it is easily dismantled by hand. If do not have minus (-) screwdriver, can try use a solid film or shim to open as show in above figure。
2. 2. Application and Setting
2.2.1 ARM & DISARM
2.2.1.1 Press once time on remote control [ ] key in standby mode, the host produces “Do..Le..Mi” sound and enter into ARM mode， after 5 seconds, a ‘Bi ’ sound and enter into alert mode. Any touch or hit is occurred at ARM alert mode, the host will trigger the alarm immediately for 2 seconds, detect on any touch or hit again within 2～ 12 seconds, the alarm will continue for 30 seconds (one ringtone type for 2 seconds alarm; 6 ringtones types for 30 seconds with automatic switching)。
2.2.1.2 Press remote control [ ] key once at alert situation, the host will produces once “Mi..Le..Do” sound and signals the host was exited from alert mode already。
2.2.1.3 When the host is still alarming, direct press remote control DISARM key to stop and exit from ARM mode simultaneously。
2.2.2. Touch Sensivity Level, Volume, SOS setting feature
2.2.2.1 Touch sensivity has 7 levels from high to low, 7 ringtones sound
prompt, Do, Le, Mi, Fa, So, La, Di; Volume has 3 levels,high, medium and low。
2.2.2.2 SOS is an internationally popular feature and off mode at factory
default setting. Note that the SOS function will recognize the installation
state of the host, so please do not change the installation direction again
after complete the installation, otherwise it may cause the function to fail
or be abnormal. After the SOS function is turned on, it will automatically
call of when the bicycle is tilted more than 45degrees by accidentally. After
corrected back the bicycle to the original position, it will turn off the call
of automatically. The SOS trigger sound is in accordance with international
conventions/standards。
2.2.2.3 Setting method
2.2.2.4 The host changes the batteries, sensitivity level and volume setting momeries will be stored. Because of SOS may needs to recalibrate, so it will automatically turn off。
2.2.6 Battery low power indication
2.2.6.1 When the host is at low battery (3.3V) condition, a weak “Du..Du..” 2
times sound was generated when use ARM or DISARM and requires to replace the
battery immediately。
2.2.6.2 When the remote control’ s flashlight becomes dark /fade or remote
control range becomes shorter, it indicates the battery power is low and
replaces with a new battery accordingly。
3. Operating Guides
-
The host uses 3 pcs AAA alkaline battery, normal usage 1~3 months; Standby (continuously): ~ 6 months.
-
WL03C: 1 pc 27A (12V) alkaline battery
WL09C: 1pc CR2032(3V) button battery
normal usage more than 1 year (Assume: 5 times usage/day) -
Operating environment temperatures: -20~+60℃
-
Operating environment humidity : R/H <80%
-
Storage temperature: -30℃~+70℃
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>