TRUMAN 85882 Dual Wireless Charger and Headphone Stand Instruction Manual
- June 6, 2024
- TRUMAN
Table of Contents
TRUMAN 85882 Dual Wireless Charger and Headphone Stand
Overview
Operation
- Plug the power adapter into the wall socket.
- USB-A side connects to the power wall adapter, USB-C side connects to the wireless charger side, the LED light will illuminate blue which means the unit is ready to charge your device.
- Place your device on to the charging stand, the blue LED light will be pulsing which denotes the device is being charged.
Power Adapter
Note: Only the QC2.0/QC3.0 Standard power adapter can support this product’s fast charging. Adapters are not included with the product.
Indicating status and protection function
- LED blue light: Standby
- LED blue pulsing light: Charging
- Blue light flashing: Device is not correctly placed on the wireless charger, over temperature protection, or detects metal on the back of the device.
Specification
Input: 9V/3.0A
Output: 10W2 (Max)
Charging frequency: 115-148 KHz Transmission Distance: ≤5mm Efficiency: ≥75%
Product size: L240W101*H258mm
Packing
- Truman Dual Wireless Charger and Headphone Stand
- USB–A to USB–C type charging cable
- User Manual
FCC Statement
This device complies with part 15 of the FCC Rules.
Operation is Subject To the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation. Changes or modifications not explicitly approved by the
party responsible for compliance could void the user’s authority to operate
this equipment.
Note: this equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 and part 18 of the FCC
Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates,
uses and candidate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. During the operation of device a distance of 15 cm surrounding the device and 20 cm above the top surface of the device must be respected.
This device complies with Part 15 of the FCC Rules. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Increase the separation between the equipment and any other radio device.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
ISED Statement
This device complies with Industry Canada’s license-exempt RSSs. Operation is
subject to the following two conditions:
- This device may not cause interference; and
- his device must accept any interference, including interference that may cause undesired operation of the device.
- his equipment complies with Canada radiation exposure limits set forth for an uncontrolled environment.
During the operation of device a distance of 10 cm surrounding the device and 10 cm above the top surface of the device must be respected.