EDGEWOOD V800W Wireless Sound Table User Guide
- June 6, 2024
- EDGEWOOD
Table of Contents
**OUTSIDE
WIRELESS
Sound Table
USER GUIDE**
Specifications:
Bluetooth: JL 5.0
Transmission distance: ≥lOm
Speaker output: 8W/40Ω
Battery: 2400mAh/3.7V
Power input: 5V/1A
Charging currency: 1A
Power bank output: 5V/1A
Wireless charging: 10W
BT ID: D042258|
FCC ID: 2AANZSPTB
INSIDE
USER MANUAL
BEFORE USING THIS PRODUCT CAREFULLY READ THE INSTRUCTIONS
First, press the on/off button of this product. Then open your smart device to
connect the Bluetooth name “EW-SPTB”. You are successfully connected when you
hear the “Beep” voice prompt for pairing.
- Power On/Off.
- Mode switch button.
- Micro USB charging input.
- Volume up button. Short pressing will change to the next song. Long press will be volume up.
- Volume down button. Short pressing will change to the previous song. Long press will be • volume down.
- USB port to optionally charge an external device.
- Speaker position. low speaker driver with high-quality sound.
FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Please note that changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
FCC INSTRUCTIONS FOR A CLASS B DIGITAL DEVICE OR PERIPHERAL
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
108g coated cart paper
Size: 80*108mm
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>