Shantou Qirong Toys 12 Piece 2.4 G Hand Gesture Gravity Spray Drift Remote Control Car Instructions
- June 6, 2024
- Shantou Qirong Toys
Table of Contents
USER INSTRUCTION
WATCH REMOTE USER INSTRUCTION
Warning
This watch remote is designed to be used on specific series of cars only. All
the pictures shown in this instruction are for samples. Please refer to the
actual situation.
REMOTE CONTROL CAR AND REMOTE PARTS INSTRUCTION
- Battery model: 3.7V rechargeable battery set
- Non-rechargeable batteries are not rechargeable.
- The rechargeable battery can only be charged under adult supervision.
- The rechargeable battery should be removed from the toys before charging.
- Remove and install the batteries: Use the screwdriver to lose the screws and open the battery holder. Install the batteries and make sure the batteries are in the correct Polarity.
- Follow the signs on the battery holder to install and remove the batteries.
- Always use the same model of batteries.
- Do not use the used batteries and new batteries at the same time or with different models of batteries.
- Batteries should be installed in the correct polarity.
- Flat batteries should be removed from the toys.
- The power terminals should not be short-circuited.
FCC ID:2A3EQQR5501
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
USER INSTRUCTION
12 PIECE 2.4 G HAND GESTURE GRAVITY SPRAY DRIFT REMOTE CONTROL CAR USER GUIDE
Switch off the remote control car to disconnect the remote control car and
batteries. Remove the rechargeable battery set. Then connect the battery
charging head to the USB charging head correctly.
CAUTION When the USB sign light turns red, that means it is charging. The
charging time is 180 minutes. It is fully charged when the color of the sign
light change to darker.
Use the screwdriver to lose the screws on the battery cover, open the battery
cover and install 4.8V. Rechargeable battery set. Connect the USB charging
head and the battery charging head correctly and then put the battery cover on
by using the screwdriver and tightening up the screws. (Batteries are included
in the package)
CAUTION
- The remote control car uses a 7.4V rechargeable lithium-ion battery, the remote uses two of the 1.5 “AA” non-rechargeable batteries.
- Non-rechargeable batteries can not be recharged.
- The rechargeable battery can only be charged under adult supervision.
- The rechargeable battery should be removed from the toys before charging.
- Remove and install the batteries: Use the screwdriver to lose the screws and open the battery holder. Install the batteries and make sure the batteries are in the correct Polarity.
- Follow the signs on the battery holder to install and remove the batteries.
- Always use the same model of batteries.
- Do not use the used batteries and new batteries at the same time or different models of batteries.
- Batteries should be installed in the correct polarity.
- Flat batteries should be removed from the toys.
- The power terminals should not be short-circuited.
Use the screwdriver to lose the screws on the battery holder cover, open the battery holder cover and install two 1.5 V “AK batteries with incorrect polarity. Then install the battery holder cover and tighten up the screws. (Batteries are not included)
WARNING
When the remote can not control the car, switch off the power of the remote
first, then switch off the power of the remote control car. Turn on the power
again to have pair by pulling the controller on the remote.
CAUTION
- Keep away all small parts safely, avoid children swallowing.
- When the electric wave disturbs playing, please find somewhere else.
- Stop playing when the battery is low.
- Dispose of all the package waste in the correct bin to avoid pollution
- Please keep the remote and the car in a cool and dry place.
- Do not storage close to the fire, heat, or wet place.
- When the batteries soak with water, please dry them properly. Do not use the battery anymore when the shape of the battery has been changed.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>