Shenzhen Snapper Technology PS-B003 10000mAh Multifunctional Power Charger User Guide
- June 6, 2024
- Shenzhen Snapper Technology
Table of Contents
Multifunctional Power Charger 10000mAh
PS-B003
User Guide
Product Diagram
Product Parameter
| Model: PS-B003 | Material: Fireproof ABS+PC |
|---|---|
| Capacity: 10000mAh/37Wh | AC Input: 100-240VAC 50Hz/60Hz 0.3A(Vax) |
| Type-C Input: DC5V-12V PD18W Max | Type-C Output: DC 5V-12V PD 20W Max |
| Type-C Cable Output: DC 5V/3A Max | Lightning Cable Output: DS 5/2.4A Max |
| USB Output: DC 5V/4.5A,9V/2A,12V/1.5A 22.5W Vax | Wireless Output: 15W Max |
| Size: 86mm86mm34mm | N.W.: 260g |
Packing List
User Guide
Applicable Scope And Charging Methods
-
Product function:
4 output ports can charge various devices at the same time. With mobile phone holder function -
Power supply:
When the power of the product is low, the product can be powered by a charging cable through USB port such as a computer, AC adapter or car charger.
Charging Instruction
-
Power status when it’ s being charged:
When charging, the digital tube flashes and displays the current power status. When fully charged, it displays”100%” and the light remains on. -
Power status when charging other devices:
When discharging, the digital tube light remains on showing the current battery percentage. When the power is lower than 5%, the digital tube flashes to indicate low battery. When in the low power state, the digital tube displays 0% and flashing, also the battery voltage is lower than 3V, the product is automatically off.
Attention
There is a risk of explosion if the battery is incorrectly replaced. Only use batteries of the same type or equivalent for replacement.
FCC Caution
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>