SPOTUCHG01 Watch Charger User Manual
- June 6, 2024
- Spotu
Table of Contents
SPOTUCHG01 Watch Charger
Product function
Instruction of wireless charging function
galaxy watch active 1 /2galaxy watch 3 This product realizes short-distance wireless power transmission through magnetic induction, and is suitable for galaxy watch active 1/2 and galaxy watch 3.
Operating environment
Working temperature0~29 Relative humidity10%~80%
Receiver location hints
Tips: The distance from the receiving distance of the watch is larger or
farther, the charging efficiency is lower, the input current at the
transmitting end is larger, and the heat is more serious.
2. Scope
This standard describes the performance of mobile power, test methods and
precautions.
Basic Performance
Electronic performance standards
Rated input voltage| DC4.8~5.3V
Wireless Rated input| DC5V/1000mA
Wireless Rated output| DC5V/600mA（max）
Watch charging power| 2.5W（max）
PCBA conversion efficiency| Wireless charging: ≥65%
Power Indicator| /
Scope of application| galaxy watch active 1\2、galaxy watch 3
Product physical reference picture
Product Size
Precautions for use
- When using this product, please check to ensure that the power adapter output voltage used is “DC5V”. If the voltage is exceeded or insufficient, it will be permanently destroyed or will not work properly.
- Use an adapter with a minimum power supply specification of “DC5V/1A” or a current output of 5 volts.
- When using a multi-port adapter or a poor quality adapter, do not connect more than one charger at the same time, otherwise it may cause unclear abnormalities such as mutual interference!
- Recommended for use in environments below 26 .
FCC Warning Statement:
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment. This
equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures: Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver. Connect the
equipment into an outlet on a circuit different from that to which the
receiver is connected. Consult the dealer or an experienced radio/TV
technician for help. Warning:In order to ensure the normal charging of the
product, please place the watch directly above the wireless charger. During
normal charging, please keep at least 20cm away from the human body.
Warning: Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.
NOTE: This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
NOTE: This device complies with part 18 of the FCC Rules. Information to the user.
- The device has potential interference,but the interference is very small and meets the requirements of the FCC rule
- Equipment system maintenance is simple, please refer to the manual
- The user can take simple measures to correct the interference. Such as staying away from interference sources, turning off interference sources, etc.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>