Maxxsonics Usa 211780005 Bluetooth Controller Installation Guide
- June 6, 2024
- Maxxsonics Usa
Table of Contents
Maxxsonics Usa 211780005 Bluetooth Controller
Product Model：21178-0005 PMN: Bluetooth Controller
Install the device
Location and Precautions:
The Bluetooth audio controller can be installed in any suitable position in
the car; Drill a 28mm hole and reserve a 64mm space behind the installation
panel.
Do not try to remove the control knob from the controller when installing; the
knob and the controller are one unit.
When connecting the cable, ensure that the voltage output is 12V, and use
the corresponding plug-in in the car to realize the connection
Usage (as shown in figure) :
Volume Control
Slowly turn the knob clockwise to increase the volume and counterclockwise to
decrease it; If the rotation is relatively fast, it will not increase the
speed of the volume adjustment;
Switching Power Supply
Press the knob inward for three seconds to turn the device on and off
Song Selection
Swipe right or down to jump to the next song, Jump to the previous song by
swiping up or down
FCC statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device and its antenna(s) must not be co-located or operation in
conjunction
with any other antenna or transmitter.
Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirement. in
portable exposure condition without restriction.
ISED statement
English:This device contains licence-exempt transmitter(s)/receiver(s) that
comply with Innovation, Science and Economic Development Canada’s licence-
exempt RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
This device meets the exemption from the routine evaluation limits in section
2.5 of RSS 102 and compliance with RSS 102 RF exposure, users can obtain
Canadian information on RF exposure and compliance.
cet appareil est conforme à l’exemption des limites d’évaluation courante dans
la section 2.5 du cnr – 102 et conformité avec rss 102 de l’exposition aux rf,
les utilisateurs peuvent obtenir des données canadiennes sur l’exposition aux
champs rf et la conformité.
This equipment complies with Canada radiation exposure limits set forth for an uncontrolled environment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>