Shenzhen Hengchangxing Electronic Materials HCXB413 Wireless Charger User Manual
- June 6, 2024
- Shenzhen Hengchangxing Electronic Materials
Table of Contents
Shenzhen Hengchangxing Electronic Materials HCXB413 Wireless Charger User
Manual
Specifications
Product Standard: Qi
Input: DC5V/2A.DC9V/2A.DC12V/2A
Output: DC5V/IA,DC9V1.67A,DC12V/1.5A
Output power: 20w/15w/10w/7.5w/5w
Charging distance: 4~8mm
Charging efficiency: ≥ 75%
Directions for use
- Insert one end of USB charging cable into power adaptor.
- Insert the another end of USB cable into the the wireless charger USB port.
- Place your phone on the wireless charger.
- Make sure use QC3.0 adapter or 5V 2A adapter.
Common troubleshooting
The indicator is off
- Please change a power cable try again
- Please change the AC Adapter (5V 2A or QC3.0 9V 2A adapter)
When the indicator flashes, but phone can’t charge
- Please check whether your phone supports qi wireless charging
- Please remove the phone case
- Put the phone in the center of the wireless charger
- Please adjust the orientation of the phone, horizontal and vertical
- Please take off the phone, restart the device and put the phone incharger center
- Please try to replace the 9V/2A or QC3.0 AC adapter.
Phone charging intermittently
- Please remove the phone case
- Put the phone in the center of the wireless charger
- Please try to replace the 5V/2A or QC3.0 AC adapter.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Warning: changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment
Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm between the radiator and your body.