NEUROX R10 Remote Control Instruction Manual
- June 6, 2024
- NEUROX
Table of Contents
R10 Remote Control Instruction Manual
Introduction
Thank you for using this remote control. This product uses 1 to 1 coding. When
the battery is installed for the first time, it can be used directly if
everything is normal without setting. If you need to perform code matching,
please press and hold the “M” button on the main unit for three seconds, and
then press the “M” button on the remote control. After successfully matching
the code, you can use it.
*This remote control has a power-off memory function, and the battery needs to be changed without resetting.
Functions
| 1. indicator | 4. increased pressure |
|---|---|
| 2. sound on/off | 5. cheating on/off |
| 3. decreased pressure | 6. mode switch |
Technical Parameters
| Model: | R10 | Working current: | 8.5mA |
|---|---|---|---|
| Frequency: | 433MHz (1to1) | stand-by current: | 10nA~1uA |
| Protocol: | MCU learning code | Launch distance: | About 30M |
| Battery: | DC3V CR2032 Coin Cell |
(Open space, receiving sensitivity is -110dBm)
Replace or install the battery
Use a tool to open the battery cover and insert the battery according to the “+/-” symbol marked in the battery compartment (CR2032 or CR2025 is common.) If you do not plan to use the remote control for a long time, please remove the battery
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation NOTE: This equipment
has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment The devices have been evaluated to meet general RF exposure
requirements， the device can be used in portable exposure conditions without
restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>