klik TAG2 Board with NTAG User Manual
- June 6, 2024
- klik
Table of Contents
TAG2 Board with NTAG
User Manual
Note: The Tag 2 devices must be installed to provide a separation distance of at least 20 cm from all persons.
Deploying Tag 2
Required Equipment: iPad and Tag 2
- Log in to the SafeLink app using the provided credentials.
- In the menu at the top right corner select “Deployment”. A corresponding map of the event location should be displayed.
- In the dropdown menu select “Deploy Tag”.
- Turn the power switch of Tag 2 on.
- Select the approximate location of Tag 2 in the map while pressing and holding the tag’s button.
- A pairing process should follow. Please hold the tag’s button until the pairing process is complete.
- Install Tag 2 as instructed in the installation part.
Note: The deployed Tag may easily be relocated, but its new location should be manually updated on the map.
Installation
Required Equipment: Double-sided tape and Tag 2
- Make sure that the deployed Tag 2 remains ON.
- Use double-sided tape to attach the deployed Tag 2 to a wall at the desired location.
- Make sure it is firmly attached to the wall.
Monitoring
Required Equipment: iPad
- Monitor the deployed Tag 2 devices using the SafeLink app. Active devices should appear in green on the event map.
IC Caution:
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) This device may not
cause interference, and (2) This device must accept any interference,
including interference that may cause undesired operation of the device.
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF exposure guidelines, This equipment should be installed and operated with a minimum 20cm distance between the radiator and your body: Use only the supplied antenna.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>