Govee H6186 RGB Car Underglow LED Lights User Manual

: June 6, 2024
: Govee

Table of Contents

Govee H6186 RGB Car Underglow LED Lights
At a Glance
Specifications
Installing Your Strip Light
Using the Strip Light with Remote
Customer Service
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Govee H6186 RGB Car Underglow LED Lights

Model: H6186

At a Glance

Car Underglow LED Strip Light Control Box 4
User Manual 1
Cable Ties 1
Clip 14
Screw 28

Specifications

Length 2 x35 Inch+ 2 x47 Inch (2 x 0.9m + 2x 1.2m)
Lighting Color RGB
Power Supply Car Battery
Voltage 12-24V
Control Way Remote
Working Temperature -2o•c – so•c C-4″F – , 76″Fl

Installing Your Strip Light

Govee H6186 RGB Car Underglow LED Lights FIG 1

Preparation Before Installing
A. Unpack the box and check whether all Items are Intact;
B. Power on the strip light to check whether It works well.
a. Connect the DC wires to the power brick;
b. Rx the DC wires on the engine compartment near the battery;
(Notice: Do not fix on the part that easily gets hot)
c. Connect positive DC wire {red) and negative DC wire {black) to correct poles of the engine.
Installing Steps
a. Wipe off the Installing surface. Make sure It’s clean, dry and smooth;
b. Remove the protective fllm from the adhesive tape and stick the strip llght;
(Notice: Do not move the strip light to other places once attaching.)
c. Remove air bubbles between the strip and surface by pressing the strip from end to end, and fix the fastener by screws to the strip;
d. Power on the strip and start to use it.

Using the Strip Light with Remote

Govee H6186 RGB Car Underglow LED Lights FIG 2

Button Function

On/Off Press to tum the light on/off.
Pause/Play Press to pause/continue the Music Mode or dynamic Scene Modes.
Auto 1 .Switch the Scene Mode among 7 options at random; 2.Every mode lasts for 30s.
Mode MODE+/-: Press to cycle forward or backward through 7 scene modes.
Music Mode Press to enter music mode.
Speed SPEED+/-: Forsame mode, press lttospeed uporslowdav,nthechanglngaf lights; Forrrusic mode, press itto increaseordecreasethe sensitivity of the mic.

Adjust Brightness Dim or brighten the light.
Color Changing COLOR +t-: Press to cycle forward or backward through 32 colors.
Color Selectlng Press to change the color. R: Red, G: Green, B: Blue, W: White

Customer Service

Warranty: 12-Month Limited Warranty
Support: Lifetime Technical Support
Email: support@govee.com
Official Website: www.govee.com

FCC Statement
This device complies with Part 1 5 af the FCC Rules. Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and (2) This device must accept any interference received, Including Interference that may cause undesired operation. Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: Thls equipment has been tested and found to comply with the limits for an amass B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to prav1de reasonable protection against harmful Interference In a
residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used 1n in accordance with the instructions. may cause harmful interference to radio communications. HOWl!lll!r, there Is no guarantee that lnterference wlll not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be detenm1ned by tuming the equipment off and on, the user Is encouraged to tJy to correct the Interference by one or more of the following measures:

Reorient or relocate the recalling antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the recolor is connected.
Consult the dealer or an experienced radlo f TV technician for help.
Non-replaceable light source.
Not Intended forllumlnatlon. Only used for creating ambiance.
Do not connect the rope light to the supply while It Is In the packing or wound onto a ree
Do not use the rope light when covered or recessed into ii surface;
Do not open or cut the rope light:
CAUTION:
RISK OF EXPLOSION IF BATTERY 15 REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.