SUNCO LIGHTING DK6-15W-5K-12PK 15W LED Downlight Installation Guide
- June 6, 2024
- Sunco Lighting
Table of Contents
SUNCO LIGHTING DK6-15W-5Kq-12PK 15W LED Downlight
SURFACE MOUNT JUNCTION BOX
COMPONENTS
EASY INSTALLATION
-
Turn off circuit breaker that provides power to the light switch for the recessed lights.
- This fixture is compatible with a 3.5 inch and 4 inch
-
Remove the lens by twisting clockwise.
-
Connect the supply wires to the junction box wires using the wire nuts provided.
• White to white;
• Green to green;
• Black to black;
• Grounding wire. -
Tuck the connected wires inside the junction box.
-
Align junction box with holes on the fixture that correspond to the size (3.5” or 4”).
-
Attach the fixture to the junction box with either short or long screws depending on the junction box size (deep or shallow). DO NOT OVER TIGHTEN.
-
Complete the installation by screwing the lens back into place (counter clockwise).
-
Turn on circuit breaker and test the light.
WARNINGS
To reduce the risk of fire, electric shock or injury to people:
- This product should be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
- Abide by related regional and local laws or regulations.
- Proper grounding is required to ensure safety.
- Check for damage during shipping prior to install. If the product is damaged, do not use it.
- Turn off the switch and circuit breaker before installing this LED light fixture.
- Do not alter, relocate or remove wiring during installation.
- Do not make or alter any open holes in an enclosure of wiring or electrical components.
- Use safety precautions. Safety eyeglasses and gloves are recommended.
- Please review instructions carefully before proceeding.
SPECIFICATIONS
- Voltage: 120V
- Wattage: 15W
- Suitable for Locations Ingress: Damp
- Housing: Aluminum+PC
- Weight: 0.39lbs
- Warranty: 7 years
RETROFIT INSTALLATION-CAN
COMPONENTS
EASY INSTALLATION
- Turn off the circuit breaker that provides power to the light switch for the recessed lights.
- Locate the housing.
- Remove previous fixture, fixture may be hot so allow time to cool after turning off power.
- Remove the lens by twisting clockwise.
- Place the springs into the keyhole slots on the back of the fixture using the Metric screws provided. Using a screwdriver, gently tighten in place.
- Slot placement should be chosen based on can size (5” or 6”).
- Step:
-
- Confirm whether your recessed can has an E26 Socket or a TP24 Connector.
- Connect the Disk wires to either the E26 adapter wires or the TP24 adapter wires using the wire nuts provided.
* White to white; Black to black
* It is highly recommended that a licensed electrician installs the ground wire to the box, if not already included in your existing can.- FOR E26 ADAPTER
- Screw in the Disk’s E26 Adapter to the Recessed Can’s E26 Socket.
- Attach ground wire to the grounding screw located inside the can.
- FOR TP24 CONNECTOR
- Connect the TP24 adapter to the TP24 connector inside the recessed can.
- Attach ground wire to the grounding screw located inside the can.
- Pinch springs and line up trim ring with opening.
- Hook disk springs into housing.
- Strong springs. Use caution when compressing springs to fit inside can. Springs can bounce back quickly and cause injury.
- Push disk into recessed can until secure
- Complete the installation by screwing the lens back into place (counter clockwise).
- Turn on circuit breaker and test the light.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>