Vibe DG-KRK Karaoke Wireless Mic + Built-In Speaker User Manual

Karaoke Wireless Mic
+ Built-in Speaker
Operation Manual DG-KRK
FCC ID: 2AANZKRK2-
BT ID: D051448
MADE IN CHINA

Thank you for purchasing the VIbeTM Wireless Karaoke Wireless Mic/Speaker & Speaker. Please read all instructions carefully before using and retain this manual for future use and reference.

PACKAGE CONTENTS

• Karaoke Wireless mic/Speaker
• Micro USB Charging Cable
• Operation Manual

KEY FEATURES

• Compatible with Bluetooth-enabled devices
• Built-in rechargeable battery
• Built-in speaker
• Volume and echo control

SAFETY INSTRUCTIONS

Keep the unit away from heat sources, direct sunlight, humidity, water, and any other liquids.
Do not operate the unit if it has been exposed to water, moisture, or any other liquids to prevent electric shock, explosion, and/or injury to yourself and damage to the unit.
Do not use the unit if it has been dropped or damaged in any way.
Repairs to electrical equipment should only be performed by the manufacturer. Improper repairs may place the user at serious risk.
Do not puncture or harm the exterior surface of the product in any way.
Keep the unit free from dust, int, etc. Do not use this unit for anything other than its intended use or purpose. Doing so may damage the device. This product is not a toy. Keep out of reach of children.

Do not expose batteries, battery packs, or batteries to be installed to excessive heat, such as direct sunlight, or open flame.

DIAGRAM

I. Microphone
2. Play/Pause
3. Volume Up
4. Funny Voice
5. Volume Down
6. Built-in Speaker
7. Previous Track
8. Next Track| 9.    Echo Switch
10.  Microphone Volume Switch
11. Micro USB Charge Pat 12.3.5mm Audio Out Pat
13.  On/off switch
14.  Micro TF Cad Port
15.  USB Media Port
---|---

CHARGING THE KARAOKE WIRELESS MIC/SPEAKER

The Karaoke Wireless Mic/Speaker comes with a built-in rechargeable battery. Before using it for the first time. we recommend you charge the battery fully. Only use the supplied charge cable to charge the speaker.
Connect the USB end to a computer USB port or a USB wall charger and the micro USB to the charge port on the karaoke mic. The red LED indicator will illuminate while the Karaoke Wireless Mic/Speaker is charging.
A full charge of the battery takes around 2.5 hours. When the battery is fully charged, the LED indicator will turn off. Disconnect the Karaoke Wireless Mic/Speaker at this point. The Karaoke Wireless Mic/Speaker will then be ready for use. When the battery is low, the LED indicator will flash red and emit three tones every 20 seconds. When this occurs, please recharge the karaoke mic.
When using your Karaoke Wireless Mic/Speaker with an iPhone, the top right Comer will indicate your karaoke mic’s battery life.

PROMPT NOTIFICATION

• The Karaoke Wireless Mic/Speaker will notify you during “Power On” with the sound of a beep.
• The Karaoke Wireless Mic/Speaker will notify you during ‘Power off’ with a prompt tone.
• The Karaoke Wireless Mic/Speaker will notify you when “Pairing Successful” with the sound of a beep.

PAIRING THE KARAOKE MIC/SPEAKER

1. Ensure the Karaoke Wireless Mic/Speaker is turned off. If it is not, please turn off the Karaoke Wireless Mic/Speaker first before pairing.
2. Press and hold the multifunction button for 3 seconds until the blue LED indicator flashes. This will indicate your Karaoke Wireless Mic/Speaker is now in pairing mode.
3. Place the Karaoke Wireless Mic/Speaker and the Bluetooth device to which you would Ike to par it within the operating distance. We recommend keeping the two devices no further than 3 feet apart.
4. Ensure Bluetooth is enabled on your device. Refer to the manufacturer’s instructions for how to enable Bluetooth on your device.
5. Once you have activated Bluetooth on your device, select the Karaoke Wireless Mic/Speaker “DG-KRK” from the list of available Bluetooth devices.
6. If required, enter the FIN code ‘030C: rand confirms the entry.
   Note: If poking is unsuccessful, turn off the Korcoke Wireless Me/Speaker fist and re-pair following the aforementioned steps. Once you have pared the Kcrooke Wireless Mic/Speaker with o device. the Kcrooke Wireless folic/Speaker will remember this device and will poi automaticity when the device’s Bluetooth is activated and in range. You do not need to re-pair any previously connected devices.

TWO WAYS CONNECTION

Bluetooth Conection& Cable Correction. You just need to connect your phone with cable a Bluetooth, and then open the singing APP on your phone. The bult4n clearly do and vividly sound effect can make you listen and silting anytime and anywhere.
When using TF cord .short press to TF CARD mode; short press agar’, fire-in mode.
If you have a USB cable connect the computer and TF CARD to it. short press to USB mode, short press again, TF CARD mode: shot press Nan, one-in mode.

OPERATING THE KARAOKE WIRELESS MIC/SPEAKER

Playing music wirelessly
Once the Karaoke Wireless Mic/Speaker is pared to your device, you can shut, music wirelessly to the built-in speaker. Select the hock you wish to learn to on your device to play through the speaker. Should you encounter any problems while *earring, please refer to your device’s user manual.
Adjust Voice Echo
Push the echo switch up a down to adjust the voice echo.
Adjust Microphone Voice Volume
Push the volume switch up a down to adjust voice volume.
Funny Voice
Long press button: Switch to strange mode 4 sounds. Short press: Switch to accompaniment mode.

SPECIFICATIONS

Bluetooth” Version:
Operating Distance:
Pick Up:
Speaker Output:
Speaker Impedance:
Frequency Range:
Sensitivity:
Ploy Time:
Battery Type:
Battery Capacity:
Charging Voltage:
Cl–aging True:
Charging Interface:
FCC ID:
BT ID:| V5.I + OR
Up to 338 (10m)
Copocilfre
3W
40
150Hz – 18kHz
83db – 115cb
Up to 3 hours
Lithium-ion
1200  mAh
DC 5V
Up to 5 Hours
Micro USB
2AANZKRK2-
D051448
---|---

CARE AND MAINTENANCE

• Do not expose the unit to excessive heat a humidly to avoid damage to the product’s end circuitry.
• Do not use abrasive cleaning solvents to clean the unit.
• Do not expose the unit to extremely high a low temperatures as this will shorten the feel of the electronic device, destroy the battery, and/a distort certain plastic pat
• Do not dispose of the unit h fire as they may explode a combust.
• Do not expose the unit to contact with stop objects as this will cause scratches and damage.
• Do not let the artist fall from high places, as doing so may damage the hotel circuitry.
• Do not attempt to disassemble the unit.

FCC STATEMENT

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) lit device may not cause harmful interference, and (2) first device must accept any interference received, inducing interference that may cause unde§red operation.
FCC INSTRUCTIONS FOR A CLASS B DIGITAL DEVICE OR PERIPHERAL
Note: This equipment has been tested and found to comply with the Emits for a Class B digital device, pursuant to part 15 of the FCC Rules. These fruits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can iodate radio frequency energy and, if not instated and used in accordance with the instructions. may cause harmful interference to rack communications. However, there t no guarantee that interference will do not occur in a popular installation. If first equipment does course harmful interference to radio or television reception, with can be determined by furring the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient a relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/N technician for help.
• Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

WARRANTY INFORMATION

The condition of this warranty and our responsibilities under this warranty are as follows:
Suppliers warranty is non-transferable. And this warranty is limited to the original purchaser only.

• You must be able to prove the date of the original purchase of the unit with a doted receipt.
• The warranty is not applicable if the product has been subject to physical abuse, improper installation, modification, or repair by an unauthorized third party.
• The responsibility of suppliers’ products shall be fated to the repair or replacement of the product os its sole discretion.
• Specifically exempt from any warranty are Emited-life consumable components subject to normal wear and tear such as batteries, decorates, and other accessories.
• A supplier will not take any responsibility the future of the unit has resulted from accident, abuse, misuse, or any unauthorized repot modification or disassemble.
• Modification and repair of the unit should be done by authorized and qualified service personnel, Center, or returned to the manufacturer.
• This warranty gives you specific legal rights, and you may also have other rights which vary under local laws.
  The follow:1g conditions comprise the requirements and scope of our warranty conditions and do not affect our legal and contractual warranty obligations. We offer a warranty on our products in accordance with the following conditions:

1. Vibe products are covered by an o 3-month warranty. We will resolve damages or defects on Vberm products free of charge within 3 months of the purchase date under the following warranty conditions. For any damage or defect determined later than 3 months after the purchase date, proof of a manufacturing fault must be submitted for repair under warranty.
2. The warranty does not cover batteries and other parts, which are considered consumables, ports that break easily such as glass or plastic defects based on normal wear and tear. There is no warranty obligation in the event of marginal differences compared to the target appearance and workmanship provided these have a negligible effect on the product’s fitness for use, in the event of damage caused by chemical electrochemical effects, by water a generally from abnormal conditions.
3. The warranty will be performed in such a way that we shall decide whether to repair the defective parts or to replace them with working pats free of charge. VibeTM reserves the right to exchange the product fa a replacement product of equal value if the product sent in cannot be repaired within a reasonable time or at a reasonable cost. Requests cannot be a mode for react to be carried out on site. Pats that have been replaced or exchanged become our property.
4. The warranty claim does not apply if repays or other work is carried out by unauthorized persons or if our products are equipped with additional parts or accessories that are not approved for our product.
5. warranties that have been activated do not cause the warranty period to be extended, nor do they trigger a new warranty period. The warranty period for any replacement parts installed ends with the warranty period for the entire product.
6. Any other further claims are excluded, especially those for replacement due to damage caused to the outside of the product, provided there is no obligatory legal liability.

We, therefore, accept no liability for occidental, indirect Cr other consequential damage of any kind, which leads to usage restrictions, data loss, and loss of earnings or interruption to business.
Asserting a warranty claim:

I) To make use of the warranty service for hardware issues, you must contact the Vibe”` Service Center by email at support@dglusa.com
2) Vibe” will try to diagnose and solve your problem. If it is determined that o warranty claim exists, you will be given an RMA number (Return Material Authorization) and will be asked to send the product to Vberm

IMPORTANT: Vibe’ will only accept parcels that have an RMA number.
Please observe the following when sending the product
I) Send the product suitably packaged with cordage and insurance paid. Do not enclose any accessories with the product (cables, chargers, manuals. etc.) unless Vibe’s’ Service Center specifies otherwise.
2) Mark the RMA number on the outside of the package in such a way that it is visible and clearly legible.
3) You must enclose a copy of the sales slip as proof of purchase.
4) Once Vibe^ has received the product, it will meet its warranty obligations in accordance with the warranty conditions and will return the product to the sender with carriage and insurance paid.
Service outside of warranty
Vibe’ can refuse any service cabin mode that is not covered by the warranty.
If Vibe™ agrees to provide a service outside the warranty, the customer will be invoiced for repair and transport costs. “tow all do not accept any packages that have not first been approved by VibeilA by means of an RMA (Return Material Authorization).
Contact us with questions at: Suppal@aglusa.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>