Hanovya YY10T Handheld Wireless Microphone User Manual
- June 6, 2024
- Hanovya
Table of Contents
Hanovya YY10T Handheld Wireless Microphone
PRODUCT INTRODUCTION
WIRELESS RECEIVER
Attention- Do not install the batteries in reverse order. The correct installation method is as shown in the figure
- Power indicator
- Micro USB charging port
- Current working channel
- Battery power and percentage display
- Real-time volume monitoring
- Actual frequency of current working
- 6.35 output plug
- Rear cover of battery compartment
WIRELESS MICROPHONE
Power supply: 3. 7V 18650 lithium battery
Working current: Single receiving::; 90 mA; dual receiving::; 180 mA
Working hours: 2000mA lithium battery
Single receiving can work continuously for 10-12 hours
Dual receiving can work continuously for 8-10 hours
Carri er Frequency: CHA: 565MHz-572MHz 15CH (CHB: 572. 5MHz-579. 5MHz 15CH)
Frequency response: 45Hz-10KHz
Display: LED digital display
WIRELESS RECEIVER
- Power button
- Display
- Metal screen
- Frequency modulation button!Up
- Frequency modulation button!Down
- Tail tube and battery compartment
- Micro USB charging port (5V-1A)
BASIC PARAMETERS
Power supply: 3.7V 18650 lithium battery
Working current: $180 mA
Battery Life: B-10 hours(1800mAh)
Carrier Frequency: CHA: 565MHz-572MHz 15CH
CHB: 572.5MHz-579.5MHz 15CH Frequency response: 45 Hz – 10 KHz
Display: LED digital display
USE INSTRUCTIONS
- Power button: Long press it to power on/off; and short press it to mute
- Frequency modulation button!Up: Press it once to increase the frequency once Frequency modulation button/Down: Press it once to decrease the frequency once
- ID pairing: Press and hold the power button and the frequency modulation button at the same time when the product is powered off, until the microphone display starts to flicker: then turn on the receiver, wait for three seconds, and press the frequency modulation button once to confirm the pairing (this operation is used to avoid interference and simultaneous use of multiple devices)
PLEASE CAREFULLY READ THE FOLLOWING INSTRUCTIONS:
-
To prevent fire or electric shock, do not expose the product to rain, moisture or sun.
-
Do not disassemble the product by yourself, as there may be high pressure inside that may hurt you.
-
Avoid to use the product in blind spots to ensure good signal receiving conditions.
-
Do not toss, drop, or throw the handhe!d microphone to avoid causing serious damage.
-
If the battery-operated microphone is not going to be used for a long time, please remove the battery to prevent battery leakage.
-
When the lithium b.=ittery is U5ed again after it i5 not u5ed for a long time, it may run out of power, or fall charging temporarily. At this time, you just need
to continue to charge the battery for 10-20 minutes to activate it for normal charging or use. -
The product is not water-proof, please avoid water from directly entering the body.
-
If the product is dropped or foreign bodies enter the product, stop using the product and contact the dealer immediately.
-
The product does not contain modified parts, please do not disassemble it by yourself; otherwise, you will lose your warranty rights, or it may cause failure to the procluct seriously
Service
Thank you for your trust and support for this product, and we will serve you
wholeheartedly.
Please fill in the relevant information to ensure your legal rights
Product model: Purchasing date: ____ Name of customer:
___ Tel of customer: _ _ Country: Address of customer·
Name of dealer: __ Address of dealer: ____ _ Tel of dealer:
Website: ___ Reason for changing or refunding: ____
This service card is a product service certificate. and the content cannot be
altered
without authorization. Please properly keep it to protect your legal rights
and interests.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>