Hebei Huachuangda Technology HCD-1235L1CON Controller Instructions
- June 6, 2024
- Hebei Huachuangda Technology
Table of Contents
Hebei Huachuangda Technology HCD-1235L1CON Controller
HEBEI HUACHUANGDA TECHNOLOGY CO.LTD
HCD-1235L1CON CONTROLLER INSTRUCTION
The electronic board is used for kid car, and controls kid car to move
forward,move back, swing. Also,can adjust speed accordingly.
Power by battery to drive motor, turn via motor too.
- use right adapter to recharge the battery, keep the value 12 voltage output.And keep away from children when recharging.
- Pay attention to the color wire to connect, take care of positive pole and negative pole. Bus line,jumpers connected correctly.
- Do not dip into water, in case of short circuit.
- Do not expose the board under rainy and sun.
- Press the button power firstly,the car is stand by. Press Rock button, the kid car swing from time to time, until the button is switched to run.
- Under the run status,step on the pedal to accelerate,loose to decrease speed. At the same time, pull the rocking bar to forward or back.
- From the acousto-optic wire, the board can receive blue tooth signal in 2.4G frequency, and operate the kid car to move. That means, the remote control box can undertake, and cell phone can undertake via APP too.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly
approved by manufacturer could void your authority to operate
this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
RF Exposure Information
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator and your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>