Guangzhou Tuoke Commerce Trade WH-E08 Blue Star Projector Night Light Instructions
- June 6, 2024
- Guangzhou Tuoke Commerce Trade
Table of Contents
Blue Star Projector Night Light
User Manual
Instruction:
- 0N/OFF Button Press it to turn on/off the projector, accompanied by a prompt tone; other operations can be started when the button is on.
- Bluetooth Button Press it to turn on/off the Bluetooth function, accompanied by the prompt “Bluetooth Mode”(Bluetooth mode). You can connect the Bluetooth “WH-E08” with your phone to play music.
- Light Button Press the button can change the light mode when the light is on.
- Rotation Button(only can be used when the light is on) Press the button to rotate the projector film and press again to turn it off.
Warm Tips:
- Please turn off the power button if the star projector is not used for a long time.
- Please turn on the power button before using the remote control.
Remote Control:
Product Information:
Name: Blue Star Projector Night Light
Model: WH-E08
Color: White/Black
Material: ABS+PC
Light Colors: Red+Green+Yellow+Blue+RGB
Power: 5W MAX
Charging:(this function is only applicable to charging type)
- ‘Please charge fully before first use.
- Do not disassemble, bump, squeeze or throw the battery into fire.
- Do not continue to use, if battery severe swelling occurs.
- Do not use it in a high-temperature environment.
- Please use the qualified power adapter(5V=1A), or use a power bank or a computer -USB port for charging. And the charging time required will vary according to the charging equipment.
- The red light is on when charging, it turns green when fully charged
Warm Tips: Limited torsion force of bracket fixing screw: 8kgf cm.
How to change projection films
- Clockwise to remove the projector film
- Rotate the projector film to install it
Note:
- The projection pattern can be projected on the wall or ceiling of 2-4 meters. (The projection effect is clearer in a dark environment)
- The projector film can be replaced according to the above replacement steps.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment
The devices have been evaluated to meet general RF exposure requirements the
device can be used in portable exposure conditions without restriction
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>