BRISTAN CR SHXDIVFF C Carre Exposed Fixed Head Bar Shower User Guide
- June 6, 2024
- BRISTAN
Table of Contents
Installation Instructions
& User Guide
Please leave these instructions
with the end user
Product Code: CR SHXDIVFF C (D6)
Specifications
Tools You’ll need
Installation
Operation
Prior to Installation
All products manufactured and supplied by Bristan are safe to use provided
that they are installed, operated, and receive regular maintenance in
accordance with these instructions.
This product needs to be installed in accordance with, and meet the
requirements of the Water Supply (Water Fittings) Regulations 1999 and current
by-laws. For full Installation Requirements & Notes (IRN) please visit
wras.co.uk/directory.
Isolation valves must be fitted to the inlet water supplies to ensure ease of
future maintenance.
Before installing this product the water supply must be thoroughly flushed in
order to remove any swarf, solder, etc.
This product must not be modified in any way as this will invalidate the
guarantee.
Full access must be made available for future maintenance/servicing purposes.
Before drilling into walls, check that there are no hidden electrical wires,
cables, or water supply pipes. This can be checked with the aid of an
electronic detector.
If power tools are used do not forget to:
– Wear eye protection
– Unplug equipment after use
If in doubt, contact a registered plumber or your Local Water Authority or
the Secretary of the Institute of Plumbing, address as follows:-
The Institute of Plumbing,
64 Station Lane,
Hornchurch,
Essex,
RM12 6NB, Tel: 01708 472791
Temperature Setting
Maintenance – Cartridge Cleaning
Servicing Intervals
To reduce the build-up of limescale and to ensure this shower works to its maximum performance we recommend this shower is serviced every 6-12 months depending on the hardness of your water.
Spare Parts
To replace any spare parts for your shower why not scan the below QR Code and search for your product.
http://www.bristan.com/products/Mixer-Showers?code=PM2%20CSHCVO%20C
Riser Installation
Troubleshooting
| Symptom | Cause | Remedy |
|---|---|---|
| No flow or low flow rate | partially closed isolation valve. | Open isolation |
valve.
Instantaneous water heater cycles on and off as flow rate or pressure is too
low.| Increase water flow rate or pressure through the system.
Head of water is below the minimum distance required.| 2 meters minimum
required.
Hot or cold water being drawn off elsewhere causes pressure changes or
instantaneous boiler temperature changes.| Do not use other water outlets when
using the taps.
Airlock or partial blockage in the supply pipework.| Flush through pipework to
ensure the removal of debris and any airlocks.
Water dripping from shower| This is normal for a short time after using the
shower.| This is caused by residual water tension, the build-up of water in
the shower.
If water continues to drip, possibly due to the cartridge| Remove cartridge
and clean, refer to ‘Maintenance’ section before starting any maintenance.
The shower does not turn on| Closed isolation valve.| Open isolation valve.
The mains water supply turned off.| Turn on mains water supply.
At Bristan, we want to make things as easy as possible for our customers.
That’s why we offer solid guarantees on all our products, effective from the
date of purchase, to give you peace of mind.
To start your free guarantee simply scan the QR code and register your
product.
Alternatively, visit
www.bristan.com/register.
For any other queries, please call our Customer Service on 0330 026 6273 where
our expert team of advisors will be able to offer you any help and advice.
For full guarantee terms and conditions visit
www.bristan.com/guarantees.
http://www.bristan.com//register
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>