linxup ATLT GPS Asset Tracker User Guide
- June 6, 2024
- linxup
Table of Contents
Asset Tracker
(Long-Term Asset Tracker)
Quick Start Guide
Account and Device Activation
Welcome to Linxup!
This simple step-by-step guide will walk you through activating your account and installing your GPS tracker. You’ll also find easy instructions to customize your Customer portal for tracking vehicles and equipment, monitoring reports, setting alerts, and much more. Let’s get started!
Account Activation
- Open your web browser (Chrome is recommended) and go to: https://activate.linxup.com
- You will be directed to the Activation Page where you will finish your account registration. Fill out the following information:
• Activation Code: You can enter either the Activation Code found on your device OR your Billing Account Number (BAN) provided in your confirmation email.
• Email Address: Please use the email address you provided when completing the order.
• Create/Confirm Your Password: Make it strong and secure!
• Read through our Terms & Conditions and then click the radio box to agree before clicking “Next”.
Device Activation
-
Welcome to your portal!
• If you entered in your activation code on the previous screen it will auto- populate here.
• If you entered your Billing Account Number (BAN), you will need to enter the activation code shown on your device here. -
Name your tracker based on the naming convention you use to manage your vehicles.
• Some common ways to name your vehicle: Blue Truck, Van ##, Sophie’s Car, Ford F150, Tractor ###, etc. -
Enter in any optional information you would like to add to your tracker.
• Tip! If you are adding trackers into multiple groups, complete Group Setup before activating the remainder of your devices. -
Congratulations! You have now set up your first device and your portal has been activated for use. From here, you can either choose to Activate More Trackers or Complete the process and begin using your system.
Installing Your Battery-Powered Long Term Asset Tracker
The ATLT device will ship with an activated data plan.
Insert the batteries where there is a clear view to the sky so that when the
device recognizes power, it has a strong cell signal to successfully report
in. Do not install inside of a building or places where there isn’t a strong
cell signal.
If your device does not check-in within 30 minutes of battery installation,
remove the batteries, wait 30 seconds and then re-insert.
1 Install the included batteries
It is very important to use 1.5V Lithium, or 3.6V Lithium thionyl chloride
(LTC) AA batteries. LTC batteries not only offer longer life but can withstand
higher temperatures. We do not recommend the use of normal alkaline batteries,
which will only power the ATLT for a few weeks of operation.
INSTALL THE BATTERIES CAREFULLY. The tracker does not have reverse-
voltage protection, so installing batteries backward can damage your device.
The springs are the negative terminals.
Once the batteries are inserted, the internal LED will come on and flash.
2 Attach your tracker
The long-term asset tracker can be attached to your equipment with magnets
(sold separately) or with #10 (5mm) screws (not included). If possible, choose
a mounting point that will give the top of the device a clear line to the sky,
and one that will not result in elevated temperatures. Once installed and
activated, your tracker will check in every 12 hours.
Install Positioning Matters
Strong signal: Installed with a clear line to sky /Weak signal: Installed vertically
Limited signal: Installed under asset
Not intended for use:
- Indoors
- Inside of metal casings
- Underground
- In remote, “no cell coverage” areas Performance and results will vary if used in the above environments.
If you need help or have any questions, contact us at 1-877-732-4980 or support@linxup.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>