Maisto 2.4GHz R/C Radio Control Vehicles Installation Guide

Maisto 2.4GHz R/C Radio Control Vehicles

Warning! Not suitable for children under 36 months. Small parts. Choking hazard. Please keep this owner’s instruction manual for future reference. It contains important information. We reserve the right to improve/revise the product specifications without notice.

Class 1 LED Product

Contents

• RC Vehicle x 1
• Transmitter x 1
• Owner’s Instruction Manual x 1

Battery Requirement

• Vehicle: 4 x 1.5V “AA” LR6/R6 Batteries.
• Transmitter: 2 x 1.5V “AAA” LR03/R03 Batteries.

Battery Installation for the Transmitter

1. Use screwdriver to loosen the screw on the battery cover and to open the battery cover. (Screwdriver is not included).
2. Install 2 new 1.5V “AAA” LR03/R03 batteries with correct polarity (+/-) as shown inside the battery compartment.
3. Install the battery cover and then tighten the screw on the battery cover.

Battery Installation for the Vehicle

1. Set the “power switch” on the vehicle to OFF position.
2. Use screwdriver to loosen the screw on the battery cover and to open the battery cover. (Screwdriver is not included).
3. Install 4 new 1.5V “AA” LR6/R6 batteries with correct polarity (+/-) as shown inside the battery compartment.
4. Install the battery cover and then tighten the screw on the battery cover..

How to Play

1. Set the “Power Switch” on the controller and vehicle to ON position, the “Power LED” on the controller will flash less than 3 seconds then stay on, meaning the automatic frequency matching between the controller and the vehicle is completed.
   

2. If the “Power LED” of the controller flash more than 3 seconds, switch off both the vehicle and controller, then turn them on again.

3. Put the trigger on the transmitter to drive the vehicle forward. Push the trigger on the transmitter to drive the vehicle backward.

4. Turn the steering knob on the transmitter to steer the vehicle to right or left.
   

5. Press the button to control dump action.
   

6. If the vehicle does not run in a straight line, adjust the wheel alignment under the chassis.
   

7. Turn the switch of the controller and vehicle to OFF position when not in play.

Performance Tips:

1. Do not drive the vehicle on grass, sand or go through water.
2. Do not drive the vehicle in windy or rainy weather.
3. Do not drive the vehicle into any hard object.
4. Keep fingers, hair and loose clothing away from the vehicle.
5. The operating range can be affected by a variety of factors:
   • Weak transmitter or vehicle batteries.
   • Interference from other items that emit radio frequency signals such as another RIC item on the same frequency, CB radios, cordless phones, high voltage transmitter, etc.
6. Outdoor usage is recommended in order to get optimal control range.

Battery Use

1. Alkaline batteries are recommended.
2. Only batteries of the same or equivalent type as recommended are to be used.
3. Do not mix alkaline, standard or rechargeable batteries.
4. Do not mix old and new batteries or different type of batteries.
5. Non-rechargeable batteries are not to be charged.
6. Rechargeable batteries are only to be charged under adult supervision.
7. Rechargeable batteries are to be removed from the product before they are charged.
8. Be sure to insert batteries with correct polarities and always follow the battery manufacturer’s instructions.
9. Remove all batteries from the product when not in use for a long period of time.
10. Exhausted batteries are to be removed from the product.
11. The supply terminals are not to be short-circuited.
12. Dispose of batteries properly. Do not dispose of batteries in fire – it may cause them to explode or leak causing injury or damage.
13. Battery change must only be made by adult.

Cautions

1. Do not attempt to disassemble the products.
2. Do not operate the vehicle with same frequency with other players in same location. This will interfere and cause the vehicle to lose control.
3. Make sure the batteries are installed with correct polarity (+/-) as shown inside the battery compartment.
4. Remove the package, take out all accessories and assemble the product before giving it to children to play.

FCC Label Compliance Statement

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

RSS-210 Compliance Statemetent

This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt RSS(s).
Operation is subject to the following two conditions:

1. This device may not cause interference;
2. This device must accept any interference, including interference that may cause undesired operation of the device.

Troubleshooting

Problem

| Cause|

Correction

---|---|---
No Function| Low battery level
Battery polarities are reversed
The wheels are obstructed by foreign objects| Replace with new batteries
Insert the batteries with correct polarities as shown on the battery compartment
Remove foreign objects on the vehicle / wheels
Drive Slow / Poor Turning Signal| Low battery level
The wheels are obstructed by foreign objects| Replace with new batteries
Remove foreign objects on the vehicle / wheels
Poor distance control| Low battery level
Strong interference of surroundings| Replace with new batteries
Move to a better location for playing

Environmental Notes

The whole product also does not belong to household waste at the end of the product life.
You can return it at collection points for the recycling of electronic and electronical instruments.
Materials should be recycled according to their respective markings.
Recycling of old devices or other re-use of materials contained therein represents an important contribution to environmental protection.
Please ask at your local community for the correct collection point.
Please retain this sheet and address for future use, as they contain important information.

Disposal of Batteries

Batteries should not be disposed of in the household waste. As the consumer you are legally obliged to return batteries containing harmful substances and all other used batteries.
You can hand in your old batteries at public collection points in your area or wherever batteries are sold.

CE Declaration

Hereby, MAY CHEONG GROUP FRANCE S.A.S., declares that this equipment is in compliance with the essential requirements and other relevant provisions of directive 2014/53/EU.

Frequency: 2.4GHz
Transmitting frequency band: 2.4-2.4835GHz
Max allowed transmitting power: <1 0mW

The declaration of conformity may be consult at:
MAY CHEONG GROUP FRANCE S.A.S.;
Pare Ariane – Le Venus, 2 rue Helene Boucher, 78280 Guyancourt, France.

The full text of the EU declaration of conformity is available at the following internet address:
www.maycheonggroup.eom.hk/declaration-of-conformity

www.maisto.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>